What Have You Done To Your 2nd Gen Tacoma Today?

How much lift you going with?

 

Installed helper bags for a new toy.

 

1” body lift from TOYTEC.

 

Looks to me like the switch panel that comes with the spod...

https://www.4x4spod.com/universal_modular_6_switch_panel_w_36_inch_battery_cable

 

Everything was going so smooth, bed took me about an hour. I have all the cab bolts loose, radiator loose, and along with the steering shaft. Hopefully tomorrow morning it’s all smooth lol!



Ran out of time, family’s coming over.

 

Installed Depo JDM Black housing headlights from Unique Style racing. Also added the extra silicone around the headlight before install.

 

What foglamps do you have

 

Nice upgrade. I did the same on my 06’ and they look sooo much better!

Here’s mine pre grill and skid plate:

 

o have the same headlights if I'm not mistaken

 

They look nice just hope the silicone holds up and they don't end up with moisture in the future.

 

Morimoto Fog lights

 

Looks great, Have you had any moisture buildup since install?

 

Finally a debadge with an application of ceramic wax by meguiars.

 

No, just cut into the upper sunglasses holder and put sPod switch panel in.

 

Replaced my needle bearing, set up to clean up was about 5 hours. Probably longer than others do it in, but it’s done. Now I just need to test drive it. Hopefully everything works.

 

Mine take on moisture when I run through the car wash....dissipates in a couple days, though.

 

Yes I have. Matter of fact, I think in this pic there’s some visible moisture.

 

silicone is the wrong way to go. silicone doesn’t bond well with plastic.

the correct procedure would be to bake them in an oven, taken apart, install morimoto gasket and seal back up.

 

I thought it was butul.or something like that. not sure I'm spelling it correctly

 

yeah morimoto butyl gasket.