What Have You Done To Your 3rd Gen Today?

Well put Joe!

 

Niiice!!!!

 

Be careful where you drive with those steps. Have seen many pictures of those missing a step from an off road excursion.

 

Went to the mall.

Got a chocolate shake, root beer float, and a diet coke all over my truck.


































You could probably see that the running boards on the passenger side is bent. A great case for rock sliders.

I got out of Northwest OHV park in Bridgeport, Texas with nothing more than a bent step, a couple of scrapes on my skid and a tiny scratch on my rear bumper.

I'm still stock (mechanically) on my truck. Damn, she can handle it!

Oh! I detailed it this evening and you wouldn't even know that she was caked in mud this afternoon.

 

Definitely worth it. Easy install. I’ve taken my grill off numerous times and figured I didn’t want to mess with undoing power from parking lights and ground. Good deal considering I only needed one but I’m sure I’ll find use for them later.

 

Cleaned mine out after a camping trip this weekend.

 

Really? Service department.Ha Ha Ha.

 

I didn't see too many with mud flaps...But, I just ordered a set of RokBlokz. Thanks!

 

Thanks! I really didn't want a step but my Mom needs it whenever she's visiting.

 

I would have also but those are a bit pricey to get shipped to Ontario Canada.

 

Update:

1. Switch pro 9100 fixed (traced a bad wire on my end)
2. Squadron pro ditch lights installed (hooked into 9100)
3. Re-ran my Baja rock lights to utilize the switch pro with the Meso BD5....now I have rear amber independent strobes!
4. Finished cleaning up the front camera wiring for the Car solutions module. Works great!!!
5. Meso dome and map lights installed.
6. Fixed ECT wiring for Meso shifter. Nor Meso’s fault but extended the wires and heat shrinked the connections.
7. Setup new tablet for mapping (Gaia)
8. Got APRS working consistently now!
9. Put in bed mat...not sure if I like it. Things don’t move! Both a good and bad thing
10. Installed OBD module....still trying to figure out whether to go with the Torque app or Fusion app

That’s about it.

Busy freaking weekend

 

Thanks for the civics lesson. My day would have been incomplete without it.

 

Pics of the fancy wiring?

 

With Montana's fly fishing? I don't believe that for a second!

 

I know it's difficult to shove things forward to make room at the back.

Keep a chunk of Masonite, aluminum, ABS plastic, or similar (thin, smooth sheet) handy to slide things over, then yank it out when you've got the item where you want it.
Store vertically along one side or up against the front of the bed.
Just a thought.

<edit> For the stuff I usually haul around, the sheet need only be about a foot or foot-and-a-half wide and maybe three to four feet long.

 

I presume same as this one?

$23 Condor Sidekick Pouch, MA64-002

https://www.amazon.com/CONDOR-Sidek...idekick+pouch&qid=1567424097&s=gateway&sr=8-2

 

Well done with 4 Roses (about 20 min from my place), but Stella???

 

I'm sitting this one out.................., in my Tacoma ........................while I'm putting on a sticker.

 

That’s it. Damn, it’s $5.00 cheaper than what I paid. You can cut the pen holder out for more room. I wedged mine in for no reason at all.