What Have You Done To Your 3rd Gen Today?

Any tips on installing the puddle lights like you have under the mirror? This is on my list of mods. I have just ordered the DSIM module to connect the puddle lights to it.

 

Scuff up the ones you got and coat them with bed liner.

 

https://images.app.goo.gl/kbj333GCm1aZefVJ6

 

I see you changed your TRD sticker on the box. Thought I was going to be the only TW member to use a Gen 1 TRD sticker. Guess there will be 2 of us.

 

Thought about it. Also looked into having them powder coated. They wanted $125 each to coat them.

 

That's the underside of the storage box, in the rear of the bed. Earlier in the thread I posted pics of these funny looking cups, but without context. THAT last post gives the context.

The cups were glued to the two large openings, to help make that box water/dirt proof.

 

I swapped it out (mostly to try gray) a couple weeks after buying it.

 

Seems legit
Mine is always full of sand. I might give this a try. I don’t have popsicles but something tells me deodorant caps might work lol

 

Hi! Phil Swift here...

 

I hot-glued the wiring that exits the box, as well as other drain hole.

I also added a pencil-sized strip of putty tape to the door jam of the box; it will be tough to open the cover, but it's only being used for the BlueSeas deck mount accessory panel that I wired in.

This is not my photo, but it's identical to what I did.

 

I'm going to order the chrome one. Think it will look good on BBP colour.

 

I’m thinking of putting the FSU head logo in matte black. Or the spear logo. Just wondering if it wasn’t centered, which it never will be, if it would drive me crazy or not.

 

Yeah, I thought about that. Wonder how you center something oddly shaped.

 

Those are pretty sweet. where did you get them?

 

Thanks!
Runningboard Warehouse. They are the GoRhino Dominator 6 bars.

https://runningboardwarehouse.com/p/go-rhino-dominator-d6-running-boards/v/toyota/tacoma/2019/

 

YITAMOTOR 23mm Eagle Eye LED Bulb Amber, 12V Ultra Thin Waterproof Turn Signal Light Car Motorcycle Interior Exterior DIY Light, 10-Pack

https://www.amazon.com/dp/B07CWQZ212/ref=twister_B07F3X7QM4?_encoding=UTF8&psc=1

Got these in 23mm size. (You may have MESO or other lights already) Took the door panel off then the mirror off. (Many videos out there ) The bottom of the mirror just pops off. (Replace with MESO light if thats what you have) I Drilled a hole on the flattest area, installed the light while using some silicone, attached extra wire and put back on. Attach mirror, run wiring down inside of door then through the door boot into the kick panel then up to the A pillar to attach to dome light wiring. Easy install, just takes a little time. If I can do it I'm sure you can. Important note: when replacing the sail panels where the mirror bolts on, remove the plastic clips from the door and attach them to the sail panel before pushing it back in. If you dont, the clips may push through the inside door panel and fall down inside the door and disappear. I know from experience.

 

I smoked a cigarette with my truck today and kicked a tire.

 

Too funny, those are the LED lights I bought already. Going to install one under the dash to illuminate the foot well areas as well. Thx for the extra info.

 

That is funny. Good luck. Feel free if you have any more questions.