Just finished the 1” body lift but...

Just installed a 1” TOYTEC body lift, install is pretty easy and straight forward.

Quick question, the steering shaft piece, I could only get it to move about 1/4” - 1/2”, should I be ok? They’re not even on both sides.



And my VSC/ABS lights on as well...lol!

 

following as i plan to a do a 1 inch body lift soon

 

Going to try and do the VSC/ABS calibration that we have here, hopefully it works out.

 

Pretty sure I’ve found the problem...

Easy fix??? Believe it’s the harness to the ABS sensor.

 

^That would do it. You need to get a new pigtail from Toyota, solder, heatshrink, and snap it into the connector. Probably about $8.

 

You wouldn’t happen to have a part number would you?? lol!

 

It's in here somewhere. The chart with the pigtail part numbers starts at page 328. The tricky part is figuring out the connector body number. See if you can see a number molded in the plastic connector. If you do, make sure it's the correct half of the connector.

WARNING: It's 451 pages, so you probably don't want to open it up on your phone.

https://www.toyota-tech.eu/wire_harness_rm/RM06H0E.pdf

 

Thanks man! So I ghetto rigged it to see if that one wire was the culprit and not any of the other wheels. ABS light went out right away, did the re-calibration and all the lights were gone as soon as I started the truck.

 

It looks like it’s this one.

90980-11002





Going by my findings, it would be:

90980-11002 would be part #12430, how would I interpret this to the dealership, sorry for all the questions man lol!

 

And pic of my ghetto rig lol!

This is temporary for tonight, going to solder and heat shrink for now.

 

At the top of the chart is the 1st 5 numbers of the pigtail part number. So... If you have the connector body part number is correct, then the part number for the pigtail should be 82998-12430.

 

That'll work for now. Good job.

 

Assuming it comes with both leads right ?

 

Nope. That part number will be for 1 pigtail. They're stupid expensive for what you get but the savings for not having to order terminals from an aftermarket source, pay for shipping, wait for package, and crimp the terminals, is worth it.

 

Hopefully local dealership won’t rape me, online is about 15usd.

 

Yikes. My dealer can get parts overnight with no shipping charge.

 

$38cdn for 1 wire plus taxes...

 

Holy schnikes! That's nuts!

 

I’ll stick with my ghetto rig for now...lol...cheaper to buy the whole harness.