What Have You Done To Your 3rd Gen Today?

I got the factory switches ( push on/off ) for mine when I did mine. I wired them into the charger in the center console. I replaced the lower switch panel because I had a Sr5. It only had 3-4 places for switches. That material on the clazzios is thicker than stock. So it takes longer to heat up IMO. BUT I LOVED THEM! Until I upgraded my truck! Good luck!

 

Got my Hammer Hangers installed yesterday finally. It's right up there or even better than OVTune in terms of improving the overall comfortability and satisfaction of driving this truck (and I say that as a daily driver that never leaves the pavement).

If you've ever heard your stock rear end 'clank' or rattle over speedbumps or potholes, or just hate how springy and cheap the stock rear feels, I strongly recommend these hangers. The truck feels so much better to drive. Install was a pain but may not be too bad if you have experience with this type of work.

My detailed post is on the vendor thread:
https://www.tacomaworld.com/threads...a-archive-garage.519625/page-66#post-21506978

 

I did the same thing, except into a tree, the day I bought my tacoma. Hard for me to swallow with the large screen and back up camera. At least I drew first blood and anyone that drives it is much safer now.

 

If you aren’t having a vibration then I wouldn’t bother with them. I had/have a vibration and so I installed them, it helps a little but I think I’m going to have to look into shims or something else to get rid of the vibes.

 

You know what they say! Take a look at how the mother-in-law looks like, before your marry! At least you know what your in for in the future.....

 

Yeah sounds like some of the crew are trapped inside. Kia's and Hyundia's as far as cars go.

https://thesouthern.com/news/nation...gn=blox&utm_source=facebook&utm_medium=social

 

Trust me, no loss there!

 

Hahahahahaha

 

Have this same problem in Colorado. Would be a sad way to lose a co-pilot!

 

Note to self and anyone running air lines and compressor, use this and not plumbers tape.

 

Just heard from a local that they found the last four unhurt not sure that’s true. Just what I heard.

 

News is reporting that as well. Alive but trapped in the hold, cutting through to them now.

 

Backflip MX4 installed. Bed stiffeners from my old tacoma. Cali raised side molle racks which I had to modify to work with the new mounting positions. Over all really happy with it all just wished backflip would have said something about the molle racks not working because you move the tie down rails lower to the bed. No biggie thou I always modify stuff.

 

Got some new tires over the weekend

 

Can't see detail on phone. Wadya get?

 

what did you have to do to the MOLLE panels? I have been looking to buy some, but i already have the backflip.

 

what did you have to do to the MOLLE panels? I have been looking to buy some, but i already have the backflip.

 

Drove back home today from Charleston after cleaning Moms yard after the hurricane passed by last week and did this.

 

Not today but I took this picture in May

 

Too funny