Let's see your FJ case swap

Thank you sir, but I thought one sensor was 4wd and the other was 4lo? Or am i wrong?

 

Helping @TacoFMS install his fj transfer case. We need to know where sensors (1 & 2)from tacoma case get transferred 3 where on the fj case(A,B, &C). Can anyone help us out? We were making good time until now and we can't contact Wyatt. HELP

 

Doh! Pretty sure you're right.

FWD drivers 4WD
AFT drivers neutral
Passenger 4LO

 

We got her now! Peeked at the wires on the other end of the plugs to figure out which sensor was which. The sensor with the external rib is 4lo, smooth outside plug is 4wd. So #1 goes to A and #2 goes to C

 

I am testing this as we speak
Single on the passenger side is 2wd/4wd
Driver side forward is hi rear sensor is lo
I personally am only wiring the 2wd/4wd

 

You've got it right except the rear is neutral on driver side. I left the FJ sensor in that spot with wires dangling. Looks like you scored some plugs

If you're doing the ADD delete and gettin rid of the 4WD computer behind the glove box, its red to gray with black stripe and yellow to brown with white stripe. Mine was different from Wyatts write up.

 

Prerunner I’m not getting rid of wiring I’m avoiding having to do wiring

 

I have the awd jack shaft from a gx470 so the only wiring is I’m adding the 4wd light

 

So the point of the wiring that is described above is to maintain the 4wd and 4lo dash lights even with the 4wd ECU removed, is that correct? The two plugs in the picture are those from the 4wd ECU and are no longer hooked up to anything. This is for ADD delete and 4wd ECU removed from the vehicle, right?

 

Correct. This way you dont have to run new wires all the way to the dash from the tcase.

 

right on! Thanks!

I just received an FJ shift boot in the mail today

https://parts.hickorytoyota.com/p/T...ml?partner=googlebase_adwords&kwd=&origin=pla

I planned on doing this mod this summer but it took longer than I thought to gather all the parts. I think I got everything now...

 

Here is mine, thanks again to everyone in here for answering all my questions.

 

Yes, and tell everyone now......who was it that didn't read his install instructions?

 

Both of us...

 

Finally got my harness from Wyatt. I have been planning on doing this conversion for nearly a year - can’t wait to get started. TC has been ordered (just keeping it simple with the J shifter). Going to try and document the process as I go.

 

I too had a pretty negative experience with Wyatt at RST. Would not return any communication after order. Kinda lied to me about a few things. The crossmember was well built I will say that.

 

Clean job!

 

Thanks buddy that was the easiest part honestly

 

Nice work, looks stock. Do you have any other photos of the shifter before putting the trim back on? I’m doing a 4wd conversion and am trying to decide on twin sticks or keeping the j-shift.