1st Gen Lunchtable Thread - General Discussion

Then it wasnt 4’ wide. I toss sheets of plywood in my bed all the time and thats 4x8

 

You dont know how to load then. Basically every truck bed is designed to be wide enough for a sheet of plywood. Its like an American standard for trucks lol

If you can a long bed full size you can play those sheets flat with the tail gate closed lol

 

If you cant load a sheet of plywood in the truck then crash it into a wall because it’s not a a real truck

 

You lay the 2x4 or 2x6 in those groves in the bed they those bitches with lay flat. Or just close the tail gate and slide them in. The bed is wide enough to fit a sheet

 

My oem toyota liner has it

 

I put sheets of plywood in mine all the time. Plus i do it with my camper shell on

 

I leave my tail gate close and just slide it in. Then strap it down



Also suck it rookie

 

No truck is. Doesnt matter. When it comes to plywood.

And for a pallet either A just push it in till it hits the wheel wells and strap it down. B if the truck has spots for 2x4 then do that or C just throw that bitch in, let her sit ineven and strap it down

 

Idk why you need it to lay flat on the bottom.

It doesn’t fit length wide in the bed anyways so it will always be un even no matter how you store it

 

This morning's balancing session zeroed in on the tire that always calls for a lot of weights. So we put it on the right rear to be less noticeable.

Is my expectation too high for a $1,000 set tires?

 

Only like full size long beds.

 

@Running Man @Sperrunner

 

The 2nd part is exactly what I would do. No need to push it in.

 

Free grille. Includes mouse nest/feces.

 

Just bring it to next years Moab meet; we'll cook burgers on it.

 

I’ve never bought HF abrasives before. I was just too lazy to go buy DeWalt disks and Lincoln wire.

 

The dealer. For example, the crush gasket for the banjo bolt of my fuel line is special and only Toyota stocked it. So I just bought it from them. Most have it in stock so you can get it same day.

 

I bought mine from Gear Tech Customs for something like $80. The material is almost a quarter inch thick.

 

These are 1/8", still twice as thick as stock.