3rd Gen BHLM and light mods

What are you looking to do?

 

Just mount the Halo to the bezel thing

 

I’d blackout the rings and inner parts. Use the same notch you have already made and dab a bit of black sealant to keep the light out. It’ll be harder to conceal it with the chrome rings. You should be able to smooth it out. Only one that will really know is you.

 

Right on. Where do I actually drill the hole for the electrical wires?

 

Up through this part?

 

I’ve done these any other drl electrical work on many lights. I refuse to drill into my headlight housings. It compromises the integrity of the light for the long term. Instead I have a system that runs them through the same black factory installed seal that the drl runs through. I’ve even wired the with and without the drl through the factory wiring on both sides.

 

That's awesome. I'm talking about just mounting it

 

Lol got ahead of myself. You should be able to feed them through the notch you already made unless I’m looking at it wrong.

 

Otherwise. Renotch at 12 o’clock

 

So my notch is offset

 

Gotcha. 12 o clock!

 

It doesn't really matter where you notch it. Most Do 12 o'clock so it's less noticeable. If you already made a notch you can use it or change it.

 

Agreed.

 

That’s ok. As long as you are good with it. If you renotch you’ll have to “fix” the old notch

 

Is this too jankey?

 

Dryer tape haha

 

Dryer tape? Heat rated?

 

200 degrees?

 

So I placed on mounting a Halo to the hi lens and a demon eye behind my rx350 lens but I don't know how. They may just sit in a box for now

 

What bulbs you running