DFW BS Thread : ********NEW MEET!! CHECK POST #1*******

Either that or they are running from two liens on the truck...

At least the plate matches what the truck should be.

 

Replace the broken wheel stud?

 

Anyone in here mountain bike? I have a few parts available. Also might be selling my BAMF shock relocation brackets welded and used archive hammer hangers with heavy duty shackles. PM me if interested

 

I do on the MTN Bike stuff, so would be interested depending on what you got, so will send you a PM.

 

Any of y’all ever replaced motor mounts on a 2nd gen? I’m having a hard time finding much info about it.

 

I've not done it on the truck, but have on other vehicles. You're gonna need an engine hoist or something to lift the engine to separate from the mounts and support it while you replace them. You can go to this link (https://cardiagn.com/engine-mechanical-05-08-tacoma/) and find page EM-187. There's a diagram that shows the location of the motor mounts and the bolts/nuts holding the mounts and brackets.

 

That’s what I was think I read one forum that had very little info but they used a floor jack and 2x4 on the oil pan to lift it and I didn’t think that was right. Should I also just do the trans mount

 

I used a floor jack and wooden block under oil pan method once before on my Honda and it didn't do any damage. Engine hoist is the better way in my opinion if you have access to one.

 

In

 

All of those will be required.

 

I need some 26er wheels, maybe a small 26er rigid frame, ISIS BB

 

Its shifters, derailleur and a crankset. Where do you ride?

 

In my dreams. I havent ridden in forever but thinking about starting back up.

Horseshoe trail was one of my favorites, river legacy for a quick workout.

 

Aaaaand here comes the supervisor

 

Just hang on a sec, lemme call my union rep.

 

I think I have an extra set of 26-er disc wheels. Just the factory Giant set if that would do you any good. I upgraded so they arent ever going back on my bike. And im probably moving to a 27.5 bike next year.

 

Ah thanks but yea im looking to upgrade also

 

I havent ridden either, I need to soon. Rowlett creek preserve is close so I usually ride there twice a week

 

I don’t have a engine hoist, but I have a fork lift. You have any idea how much wiggle room I have, and do I need to disconnect the trans or at least trans mount?