What have you done to your Tacoma today? 1st Gen Edition

Before and afters of my build

 

You cut the rear O2?

 

No, I used an old O2 sensor to plug the hole where my air/fuel sensor was when I removed my supercharger.

 

Need to do this.

 

which resolution is this pic set at?

1280x720 - 1920x1080 - 2592x1944

 

It's

1280x720 on my phone, I haven't played with the settings much.

 

i was just curious if it can be an even sharper image is all

like these internal shots from the eastwood internal coating webpage

 

Mmm maybe. The lens on this thing is fixed focus and doesn't have a huge depth of field, so getting a shot like that is going to be difficult. But upping the resolution can't hurt. If I get some time later I'll play with it

 

Thanks for the link, probably going to order one of those up soon.

 

it would be great if this device gets some real fine resolution so some Tacomas in CA,AZ,etc can get some internal pics of what its 'supposed' to look like inside there with factory paint.
for comparison and curiosity purposes if anything

 

Thanks for sharing. Ordered.

 

LBJ Failure?

 

Got my new gen3 smittybilt installed yesterday and controller box relocated

 

YEs

 

Okay I’ll order those then

 

What exactly happened here? Didn't sound like the typical LBJ pulling out of the socket.

Edit: just caught up on the thread...

 

Friends, here is my California State vehicle bought from the auction. According to dmv its previously registered as an undercover vehicle. As you can see I changed the rims to metal for the time being. I need to paint the original which shows some scratches. Thanks

 

Please note the offroad tires installed are a little bit smaller and stance of the truck is lower. Not sure why the State used a smaller set of tires. For 107,000 miles I can’t complain. Thanks

 

I already have several changes or
improvements done to the truck and will share the list as I go on. Infact I have the parts that have been removed and replaced either from Pic n Pull or bought in Ebay. For now the major improvement I am doing is spraying the metal frame and underchassis with rustproofing for rust protection (as you can see it the first picture I started spraying half to see the difference with the current condition). I think never in the trucks life was there any rustproofing applied to it. Anyway there is no visible rust as seen in the frame and rare do
you rust in vehicles here in California. Thanks

 

Oh by the way the 2000 Tacoma
4wd is fairly new to me. I previously owned a 1991 Toyota Truck bare to the bones stick shift no bells or whistles that was totaled according to my insurance. It was a hit and run grrrrrrr. Sad to say I had to part with the vehicle. Thanks