What Have You Done To Your 3rd Gen Today?

I FINALLY reprogramed my aftermarket TPMS sensors to my new wheels. No more TPMS light on. My buddy shipped me his TPMS tool from NY and it worked beautifully, well after a couple attempts lol

 

Awesome it’s a big metal bumper use a floor jack to put it on much easier

 

What a dick. LOL. Oh, by the way, Hell-o.

 

Nice! May I suggest that you use Rivit nuts aka nut-serts instead of bolts and nuts. That way you could easily move the ram-balls around without removing the dash.

 

You're fine Bud, don't sweat the small stuff.

 

We got a little off topic a few pages back. It's OK. We do that on this thread sometimes.

We had a bit of some back-and-forth about Texas.

I'm going to get back to what this thread is about. What I did to my 3rd gen today.







































Today, I mounted my Texas flag.

 

$210 Start-X Plug N Play Remote Starter Kit for Toyota Tacoma 2016-2023 & Toyota Highlander 2014-2019 / Key Start

https://www.amazon.com/Start-X-Remo...068&s=car&vehicleId=11&vehicleType=automotive This one is for key start cars and you simply press your un-lock button 3 times.

 

Thanks. My floor jack is small and won't go up that high. I'm pretty resourceful when I have to be. I'll just improvise using a little Yankee ingenuity.

 

I'm 65 and did it by myself Bob. Put some hooks in the rafters of the garage and attached two sliding straps to pull it up! Worked like a champ!

 

Thanks for the suggestion! I was going to add nut plates but decided on the simpler route.
The hardware are spaced out in the center to accommodate 2 more ram-balls (have extra laying around) when I want to mount more gear, but that won't be in the future.

 

Brought some firewood for the weekend.
Campsite lit up at night.

 

Thanks for the suggestion but no garage. What I do have is a Mahindra and plenty of webbing.
I'll figure something out. Where there's a will there's a way and I can be a stubborn little Harp!

 

Had a hole in my stock muffler that hung too low anyway so I had a new one installed! Dynamax super turbo muffler turned down over the rear axle.

 

Welcome to TW Aaron!

 

Psyched to install my OME 2" lift with BFG's KO2's and the Diamondback Cover today. Loving the ride and grinning from ear to ear. Drives great and very happy with the OME. On to the next mod....

 

That’s purty

 

I got a rivet nut insert tool a while back for a project on my old truck, since then the only excuse I had to use it was to replace the crappy little plastic clips on my wife's 2017 Civic's belly pan with M6 bolts. I'm always looking for excuses to use it. In reality how often do you move your phone mounts? Not often enough to fuss with rivet nuts.

 

Picked up this little guy today...

 

Got a couple of things done over the last couple of months, namely dual batteries, ARB compressor, and ....an Anderson quick connect setup for jumper cables......

 

Installed some eBay bling, got rid of the stock TRD OR grill