Post your SCS wheels + 2-3” lift + 265 75 16 + MGM

Why do I feel my access cab mgm with this setup would look absolutely amazing?! Sure someone on here has to have it lol

 

Lots of trimming to get that offset to work? Deciding if I want to do the 17x8.5 -10 or the 17x9 -38 offset. Truck looks good btw.

 

Thanks. OME 885s up front, Headstrong add-a-leafs with overload delete, u bolt flip, wheelers superbumps front and rear, dirt king UCAs, 5100s on the 2nd notch up front, CMC with fender/pinch massage and it still rubs. Netted 1 7/8". Haven't measured in a couple thousand miles though. I carry a lot of weight regularly, 200lbs of cargo. Sits level.

 

Depending on tire size, -38 looks great. If I were to do it again, I may have gone with a 17x8.5 -10 to clear the cab mount a little better with my 285/75/17s. But... I’m not in a hurry to get rid of my wheels yet. Love that that tire poke.

 

I'm looking to put bfgoodrich ko2 tires on my 17 tacoma. Upgrading from 265/70R16 to 285/75R16. Everything is factory no lift or anything. Will these tires fit without any clearance issues including width of sticking out from under the fender flares? Toyota dealers can't figure it out for some reason.

 

Depends on the offset, but most likely will have poke with 285s and SCS wheels unless you go 0 or + offset.

You won’t rub on UCA though.

 

So 285 likely a bit wide. Apparently they don't make a 275/75r16. What would be recommended to have that aggressive tread and still fit good without rubbing at all?

 

265 75 16

I have steelies with -6 offset currently with that tire above no rub.

You go much bigger you’ll get a little rub on stock suspension

 

Sir, I didn’t even ask, what suspension are you running in this picture?

 

Another pic

 

Picture's?

 

Of what?

 

Love to see a close up picture of your tire and wheel set up.

 

I don’t have that setup anymore but here’s what it looked like and what’s on now..

265 -6 up top

285 -12 (ray 10) bottom


Haven’t had rub until now, only on cab mount which is getting chopped this weekend. Still stock suspension. I heat gunned my fender liners back and cut bottom tab of fenders that pokes in toward the tire. Super easy. Won’t lift 2-3” until I go to 35s after regear.

I love these ray 10s but need them in black or bronze - gunmetal is too flashy for me especially when it gets direct sunlight.

 

Ray 10'S look great, I have the gunmetal Ray 10'S in the 16x8 -10. I hope to not have any rubbing issues my self, thanks for the pictures. Your truck looks great!!

 

No prob. @kennethalan has the perfect example of how sexy Ray10s are on his 35s.

 

Damn. Thank you so much. I really appreciate that.

 

Are you rubbing anywhere on road or offroad?