1st Gen Lunchtable Thread - General Discussion

Lift the front left a little and it should correct the taco lean

 

Pick up an engine hoist from Harbor Freight. Makes the job 100x easier.

 

Or just buy a six pack and invite a buddy over

 

I’ve done it lifting it with two people. Still sucks. You have to lift it high enough to clear the fuel neck.

 

But it’s cheaper

 

Yeah, I’ll give you that. Always nice to have an engine hoist.

I’m installing an electric hoist from the joists in my ceiling. Going to use 1 5/8” Unistrut on a slider.

 

I actually have the HF engine hoist. Does hooking it to the rope hooks work ok?

 

Absolutely. Make an ‘X’ with two of them and lift from the center.

 

I understand this meme now

 

I have cried twice in my life. Once when I was seven and I was hit by a school bus, and then again when I heard that Li’l Sebastian passed.

 

Found a cheap e locker third, already putting the new truck to work

 

How much? I’ve had to put my locker third together piecemeal. I bought he housing separately, the shafts separately, and the third separately.

 

@Wulf

Also where’s the pics of this great new truck you’ve bought?

 

'02 and up I take it?

 

The locker? Came on 98-04

 

No, the entire assembly he posted.

Just checking to see if I'm right in thinking that the e-brake line runs across the rear end on an '02 and up vs over the housing on a '96-'01.

 

I thought you could get an elocker before 1998, just wasn't a TRD package before then

 

Hell no, mall crawler ftw