1st Gen Lunchtable Thread - General Discussion

Huh?

My tundras painted. Body shop did it all

 

@Wulf

 

Oh was that pic of it completed? Thought they were wrapping it up or something, looked like lights weren't in place yet etc. So I just figured was still in process

 

Wtf Lmfaooooo

 

I have and like this one:
https://www.homedepot.com/p/Weller-...ing-Cordless-Butane-Solder-Iron-P2C/302575927

 

total bummer that to get the required SCFM it will cost another $500 from that prior compressor

 

We sand blasted an entire car worth of suspension parts with a mid-90s vintage 5 hp, 5 gallon Sanborn black max. Shouldn't be too hard to find something similar today.

 

@Wulf https://sfbay.craigslist.org/eby/cto/d/fremont-2000-ford-super-duty/6990444839.html

 

They still have to do the bedliner. I believe it’ll be done today

 

Saw a 3500 Chevy full backup send it into a Tacoma walking to class rn. Didn’t even check behind them.

 

Git you one of these bad boys

 

thats tiny

 

I mean it fills the 400 or so gallons behind it pretty quick. Its a scroll compressor pumping 135CFM at 90psi. It only serves half our shop, there's another one near the CNCs since they use a lot of air too. Also damn near silent

 

Show off

 

The Kaeser compressor at my job dwarfs that thing. I would grab pics, but I have a thing about not posting job pics on the internet/social media.

 

Pics or its fake. In all seriousness though you don't have to take pics of it, I believe you, you probably have more air operated stuff than we do. Ours is mostly hydraulic.

 

that is probably several grand?
very high SCFM, i only need a bit less than 9

 

135CFM at 90psi ... is this 135 ? or typo 13 SCFM