What have you done to your Tacoma today? 1st Gen Edition

That part# 4' 1/4 hose and a zip tie to hold it up. You can drill a hole under fuel door and vent it next to gas cap.

 

Thanks. I think for the breather itself I'll use this:

$6 Dorman 924-284 Front Differential Vent Breather Compatible with Select Lexus / Toyota Models

https://www.amazon.com/dp/B06XHBY38...olid=1TFPVHIWCQ8CD&psc=1&ref_=lv_ov_lig_dp_it

I'll go buy 4 feet of 1/4" fuel line or hose and clamps locally.

 

Went camping this last weekend and did some exploring down the coast.



Also finally got my sliders installed last Friday. Just gonna finish painting the welds.

 

Looks good! I remember the first time I got my sliders on I was super stoked about not needing to worry about slamming on rocks anymore.

 

Finally confirmed my EGR is functioning normally. Huge relief for me and dropping it off to be smog tested tomorrow.

 

Thanks. Definitely glad to have the extra peace of mind and functionality. Not to mention the protection from other people's doors and being able to easily clean off the top of the cab now.

 

You got any pics of the mounts welded to the frame?

 

Probably a stupid question, but I'm known to be stupid so here it goes...

Was looking to hop on the RCI group buy and they have 3rd gen 4runner front, trans, and tcase skids. I know the front and trans should bolt up without issue, but the tcase is only listed for the 4runner and I'm not sure if crossmembers might be a little different or what not. Anyone use these specifically or another 4runner tcase skid on 1st gen without issue?

 

That. Proportioning valve and cutting brakes. all in the cab

 

Not on hand, but I can grab some for you tomorrow

 

Ordered a clutch kit for my 2.4 today. My dads shop can get things wholesale so a whole kit with clutch plate, pressure plate, flywheel, alignment tool, and throw out bearing was $128 plus tax

 

Installed rigid D series pro floods today!

 

nice! my dads shop cant get me anything like that

 

I've been thinking about replacing the fuel pump in my rig, if for no other reason than to knock two birds with the one stone (however that goes...)

is there an approximate mileage or time elapsed that this procedure would be a wise thing to get taken care of?

 

They all last differently, but my pump quite around 300k and dead on the side of the highway, no warning

 

is that a $300 part or $80 part, was just shuffling through some old topics on the fuel pump and saw a couple of numbers

 

Just bought these parts.

 

Bummer man

 

excuse my shitty welds. The upside down weld on the bottom of the plate along the edge of the frame was the hardest to do. Should hold fine though.

I wasn't able to get to the top of the plate to weld it with my MIG so I just sealed it with some clear silicone along the top to try and keep liquids from getting behind the plate.

still have to wire wheel the surfaces and hit it with some paint.

 

I figured so. I saw your story on IG and noticed that you didn't have the top welded either so I figured i'd be fine if it's held up long enough for you like that.