What have you done to your Tacoma today? 1st Gen Edition

Amen, took me forever to find a rear bumper that I liked. This one fits the bill pretty well.

https://www.coastaloffroad.com/prod...high-clearance-rear-bumper-kit?v=7516fd43adaa

a bunch of us from middle TN were able to get a group rate on a bunch of armor so the price was really good also.

 

it had 3 owners that probably knew nothing of the problems if not kept clean or did not care whatever, probably no notice from Toyota to get it checked 10 years ago
literally driven into the ground until collapse (most likely) and left dead on the side of the road abandoned with a sticker to please remove vehicle
or the engine blew, it was a mess too

 

what was wrong with the genuine authentic original?

 

He’s saying he got a new frame from Toyota

 

what was wrong with the original?
what was the need for new one

 

This.

 

RUST

 

is that dirt or dried mud all over?

 

i will have to check that spot on mine
the expert inspectors have given it the AOK Toyota seal of approval

 

I'm in northern California. A little NW of Sacramento. I do go up to Forest Hill pretty often so I will see some snow, but not that often.

 

word to that!

 

unless there is sodium in the snowmelt or you stuff your frame with McDonalds fries (extra salty) should be ok! but can never be too careful
this Toyota paint only seems to be defective against chemicals upon limited ongoing research

 

That's dirt, but screwdrivers should not be able to go through metal.

 

i thought that was a drain hole at first?

 

What is the TW recommended frame paint then? I do have access to people who can lend me a paint gun to do this myself. I want to start with a good base then protect the frame with Fluid Film moving forward.

 

not sure there is a consensus yet! ... many opinions on TW
I am trying the Eastwood extreme first and see how it handles winter chemicals (and chipping)

 

can someone help me figure out this speedo correction calculator? I'm not sure the revs/mile or the drive gear teeth. I have a 5 speed (R150F)

https://www.monstertransmission.com/Speedometer-Gear-Calculator_ep_122-1.html

 

Thank you!

 

Should put some along the sides of the truck too, so when someone tailgates you and you blind them, and they speed up alongside you to give you the finger, you can blind them a second time haha

 

Not sure I mentioned this before, but you should extend your exhaust past your shocks. That passenger side shock will rust/corrode way faster with the exhaust dumped like that.






Oh, and 1st gen in the banner again.