1st Gen Lunchtable Thread - General Discussion

Life is too short to drive boring cars, I legit will never understand and have zero desire to understand folks who buy econoboxes

 

He went full send, you never go full send.

 

Only 1 minor accident. No damage. No low balls i know what i have 25k firm

 

Its a used ram, wasn't worth 25 when new unless it was a diesel. Now it actually owes you money

 

but muh fewl economee...


Idk, some people value other things I guess. Some people wonder why Im content with the computer I use or house I live in. It works for me and allows me to focus my interest on the things I enjoy most.

 

Wtf happened

 

Whelp back to work. Yay over time

 

Miguel just over here fixing one walk in and sabotaging another on his way out.... Racking up that ot lol

 

Im surprised that OV tune 3rd gen supercharger thread hasnt gotten locked yet. Whenever I look in there the OVtune guys are schooling some douchenozzle who seems to know way more than they do about what they're doing.

This is tonights gem.

 

Good. Thanks for getting my call. See you in a few hours.

 

Im over 8 hours of ot today so far

 

Maybe I could’ve removed it more carefully, but Toyota says it is not reusable.

 

I know what it says, but they don't break or even get oblonged (go look at the pic of the used one I have laying around) if you don't go full 200lb gorilla on em. You can run em forever if you'd just be more careful. You don't see people replacing the one on the diff side everytime they pull an axle, hell most axle refurbishers don't even replace em.


Also.... okay Facebook meth head...

 

Gas mileage. And the fact that my corolla will never die is why I have it.

Surprisingly it’s fun to hoon around too.

Avalon is boring but it’ll eat up the miles in comfort. (I also got a 15k mile engine that runs with a bent rod for free... soo eventually build it and shoot for 350 hp n/a?)

 

Just because of this, I'm going to add those to the list of little odds and ends to replace.

 

Could be also I didn’t have the correct snap ring tool. I was using the hole style tool.

 

I'm talking more like Yaris and Echo status not Corolla

 

Speaking of which that's one tool I've used from HF I would not recommend...their snap ring plier set blows. Used it to replace the bearings in my coilovers and the pliers come apart way too easily when you put any pressure on them to compress the ring

 

Not going to lie. Drove a 2zr swapped Yaris at a autocross event.



I liked it

 

There are a lot of odds and ends you’ll need for this swap like manual hub gaskets, the brass safety bolt that goes on the end of the CV, little C clips for the axle on the diff side, axle oil seals, etc.