Gauging interest for Rear Electrical Panels

count me in as interested!

 

+1 on the overhead switch panel!
Also would be interested in a back one if it's water/dustproof.

 

Interested in your overhead switch panel... just need to see what it look like before committing

 

right on bud

 

Of course ! We’re getting very close. The CNC ships in a few days so we’ll be posting pictures ASAP.

 

I'd be interested in your under the hood panel for 2000 and prior manual transmissions and possibly the overhead switch panel as well.

 

Any overhead panel updates?

 

the Cnc company had some type of issue with our order. It’s being shipped today. I’ll update you guys as soon as possible.

 

Same here for my '99 MT.

 

Interested in the hood panel and overhead switch panel.

 

Hey everyone! Just wanted to check in and update you guys! First off thanks for being patient I know it’s been awhile since I first made the thread. The CNC has arrived and we’re going to assemble it over Wednesday/Thursday. One important part of the machine was on back order so we’ll have to wait to cut till we receive and install it. If anyone wants update pictures check out @lampsonfabworks on IG

 

Hey everyone! Another update. The CNC table is built and we’re beginning to do some test cuts and getting the bugs out. The THC arrived yesterday and we’re getting it installed. We’re having a slight issue with one motor not firing when it should. We want to get this figured out before we waste material and we won’t be selling products that aren’t right. Thanks for your patience and we are getting close!!

 

Update motor issue resolved!! I’m hoping to get some panels cut by the end of this week or early next! Stay tuned

 

Hey everyone just wanted to give you guys an update. I ended up getting a new job at a bad ass hotrod shop. It’s going to be badass in the end because I have access to a full metal shop, CNCs, and 3D printers. The fabricator I was working with ended up going a different route so I’ll be doing all my tacoma stuff with my guys at work. I apologize for the delay but life happened and delayed this project for a bit. Hopefully I can get some stuff done soon like I promised. Hope everyone is doing well
-Ken

 

I’m interested in a rear panel depending on price point!

 

I'm interested depending on price !

 

Count me in as interested in the overhead switch panel please!

 

Any updates?

 

yeah sorry it’s been awhile since I posted. I’ve been extremely busy with work since I started at my new job. On top of that I had 4 lithium ion batteries explode in my hand last week so it’s set me back a little. I’ve been talking with my 3D printer guy at work and we’re looking into doing a molded switch panel rather than the aluminum design I had before. The rear electrical panel will remain made out of aluminum or steel.

 

Still excited!