1st Gen Lunchtable Thread - General Discussion

That could be possible. Not sure I'll be ready to do that til post Thanksgiving

 

I have 3 8.4” axles and a 7.5”

 

his truck is a elocker.

no rush. his has time. the things just rotting bad. im just curious because my spare housing is just as rusty as his.

are you going to be using the axles too?

 

Just modify the 8.4” lol

 

that involves welding. and i'd rather just be simple swap housing out and roll with it.


i might take you up on one later though when the time comes for me to make the other frame "driveable"

 

I have 1 complete 8” and one bare housing. Also like 6 spare 8.4” axle shafts

 

i have 2 8.4" diffs.. one with LSD.
3 Elocker Diffs
1 elocker housing with a 4.10 ratio gear thats in good shape.
3 front diffs all 4.10 gears..






housings are what i lack. but i need to offload these diffs. theyre all worn out. i just want to keep one of each

 

I need a manual hub front diff.

 

that i do not have sadly.

 

Damn

 

I was gunna trade you a axle

 

lol. all mine are ADD tubed.

 

Ill just buy @Tour991 manual stuff

 

Don't buy Toyota stuff, otherwise you'll be that guy that said he was going to buy a ram coal roller and it never happening ..cause your monies went to yota parts.

 

No sir, the diamond housing is setup to use Dana 44 front spindles/brakes/hubs and has FF stub shafts between the diff and the hubs

 

i may need to jump on the shafts too then. lol i have a bad issue of hoarding... just PM me whenever your done with what you need.

 

Actually be that guy that didn't get the roll coaller.....

 

It's a 2000 housing with ABS. Was told it had 100k mi with 50k on the fluid and it came out still greenish so if believe it

 

Or you can be me, spend money on both, and have none left over

 

Third is the same, you need the manual axle tube