Rear Husky Liner fit problems?

Purchased Huskey Liners front & rear floor mats for my 2017 TRD Offroad a few weeks back. Front mats fit perfectly around all edges and borders, and lay flat along the door jams.

Different story for the rear mat. When installing it, I figured it was just stiff from packaging, but the outside edges never quite never settled. Looking closer, they don't appear to be sized properly. Even if the edges were sitting flat (I can push them down a bit), the ridge in the mat is too high and the edge appears mis-placed. I'm confused because all other dimensions of the rear mat (around the seat anchors, center hump, etc.) fits laser perfect. Front mats don't have this issue on the outside edges.

Does anyone else have these mats and does the rear fit like this???

 

I actually had a similar issue with the front. Just take a heat gun (or hair dryer) and soften it up a bit (just don't go to far).

 

Here’s mine. 2017 DCSB AT. Husky Xact contour

 

mine does that. been too lazy to fix it

 

Mine don't fit either and got worse after putting the spacers on the back of the seat. I just had to quit worrying about it. I guess I could try the hair dryer.

 

The outside ridge should extend a lot further.
Tried pushing up on it?