Ontario BS Thread

So you jumping it next summer? That suspension needs air time

 

Lol Shift knobs... I was looking at shift knobs a couple weeks ago...

 

Hey @BlueTacoJR welcome!

 

I have 2 @7r41lbr34k3r knobs. 1 Al and my Ti...its a sickness lol

 

Well after watching that Video...

I can see that he had too much "Jounce" in his take off.... 8112's should take care of that....

His front facia blew off .... so I figure the Warn bumper will fix that issue...

8112/8110's have built in bump stops and I'll leave the factory ones in so the landing shouldn't be an issue...

What the hell,

Here, hold my beer.....

 

And there goes quality control at yota....

just kidding @Norilsk is a stand up guy....

 

Can’t be worse than leaking third break light, howling diff, leaking engine gaskets, squeaking clutch pedal, missing glue under hood brackets, constant rebooting entune, dead batteries after 12 months, poor paint quality, faulty tss sensors, rotten frames....

 

We’re about to find out. Just make sure the battery terminals are on....

 

I am convinced something isn't right too.

I do have a lot of negative camber, especially on the driver's side. I keep going from alignment shop to alignment shop to try and see if anyone can do better. It's getting better but no one seems to understand when I tell them what I want.

 

Need to go to crown. They did a few rigs. They know what’s up.
You have aftermarket uppers right?

 

I have TC. I am planning to go see them for sure.

 

They did mine, joes and evgeny. They are grumpy, take there time but you leave with a good alignment.

 

*their ... fvcking educators these days

Who luvs ya Pete!

 

Careful what you wish for!!!

 

It’s late and auto correct isn’t my friend....

 

My sliders are on the way and I need to paint them and get it on the truck before it gets too cold. Do you guys apply anything before primer once it's clean?

 

I use a metal prep that etches the material. Leaves a zinc or phosphate coating that promotes adhesion of The paint.

 

@Tridet167 you need to see my buddy at tire craft

 

Tacomaworld special

255/75r17 BFG KO2 32x10r17

5 tires, 1 brand new. Others have 3-4k km on them.

$900

 

Well starting the pilling of parts for the next stages.

All us non-rusty Canuks know the size of a Fluid Film can, and since I couldn't find a banana...

Interesting thing I noticed was the shock body was pretty much the same diameter as the Fluid film can.


Only way to make these look better...

Is to get mud all over them....

Rear springs may be in tomorrow.

Gotta tell myself... patience.... don't put them together and on tonight... lol

Ordered the Spod Bantam /HD today too, while shooting the shit with Erin at 4wparts Burlington, he's a Jeep convert to Tacoma's too.
Always nice and handy having a guy at the parts counter that's modding the same model of truck as you are.
They had quite the selection of portable air compressors in the showroom, Arb, Smittybuilt, G2, Viair.
Had to look quickly or I would have been dropping another grand for sure lol.