What Have You Done To Your 3rd Gen Today?

I’ve seen a lot of people using 5100’s just raise the spring perch one notch on the drivers side. If I recall correctly that was even mentioned in the Bilstein instructions. I was tossed between both options bouncing back and forth between wanting the same preload on both springs and thinking the heavier side might benefit from the added preload. I ended up ordering the headstrong 1/4” spacer but still haven’t gotten around to installing any of it.

 

Installed new nerf bars. They are the Tyger Amazon bars $300 free shipping fit perfect. Probably won't stop much but other people's car door smacking mine but they seem tuff enough and make it much easier to reach the roof rack.

 

I plan on doing the same thing with a spacer and 1 notch pre-load(ran out of time this summer) in the spring. Only got 5100 installed in the rear and the RMAS kit to give me some lift. I would like to know your results when complete.

 

Added AVS window visor and some Ebay all weather floor mats today

Got the floor mats front and rear for $90 shipped. Very good fitment too

 

Filled the tank.

 

...... you're not in California. I haven't seen those gas prices in awhile

 

That's nice.

 

Installed sso bumper today with winch. Didn’t get a chance to do the slime line high clearance sides yet but that will be tomorrow.

 

Rode some slick, leaf-covered trails today

 

Black badges installed.

 

Changed oil & Filter, tire rotation and installed Pop & Lock. Also ordered N2 Designs remote start.

 

North Carolina.

The price was 2.24 i think, the grocery store does gas points. The do triple points Tuesday, plus they send 100 point coupons, 50 point prescriptions.

I save all my points, shop big on Tuesday and use the coupons. Then they sometimes scan the 100 point coupon at the self check for you.

Anyway, after saving for the month i use it at the beginning of the next month.

I average one fill up a month between 70 cents and 1 dollar off. My best was 95 cents. I paid 1.34 that day.

 

Threw on some RCI racks! Took a lot longer than I thought. Lots of bolts/washers/screws. Tough and sturdy as crap though.

 

Hope to get mine by December. Did you take the whole front fascia off?

 

Looks awesome btw

 

235/85-16 Falken Wildpeaks on steelies. Repro vintage Toyota hubcaps.

 

Replaced the diff breather union to fit the 5/16" fuel hose better. Left is P/N 90404-51026 installed 7 months ago, for 1/4" fuel hose. Right is P/N 90404-51319, for 5/16" hose.

 

Thanks I think so too. No bumper removal or front grille. Just took center piece off and good to go. Save yourself some steps

 

No cutting, just replaces the air dam?
Any chance of getting a side view?