What Have You Done To Your 3rd Gen Today?

There is a little rubber wheel that attaches to your drill or cordless drill gun that makes this process of vinyl removal take seconds...I know I’m a bit late but for future reference

 

I have been considering the tailgate flat "cutting board" mod but need to know one detail. Is the flat portion equal to the raised dimensions of the original or is it equal to the indented portion?

my dilemma...I have a Yakima Long Arm that I carry in my bed. The long arm portion squeezes between the front of the bed to the tailgate when closed. I took off one of the end caps on the bar to release pressure on the tailgate but would like to keep the gear ready for use.

if measured from the front of the bed (raised portion) to the closed tailgate with the new cover; is the measurement the same as original or slightly less?

thanks

 

About to install my seats tomorrow or friday. My switches have 4 wires, one for ground, one for constant power, then I have illumination and one for ignition. Wondering if you bought the same kit, and where you rain the illumination and ignition wire

This is the kit
https://www.amazon.com/gp/product/B01MEE6KLX/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1

 

Rolled the windows down this morning. No issues

 

Did you fix the bowed out issue? If so, how did you fixed it?

 

Do you know what the weight of the rebounds are? I can't find it anywhere online

 

I bought the rostra kit from clazzio when i got my seat covers, my kit just had the power, ground, and illumination wires, no ignition wire. I tapped into S/HTR and S/ROOF for each seats power, and TAIL for the illumination wire, (i joined the separate illum wires from each seat into one 16 GA wire and used a fuse tap), my thoughts on where to get ACC switched power for your ignition wire would be IGN 1 on the fuse block or connect it to the 12 volt port in the center console. if you need pics on where to route the harness PM me your email and i will send the photos i took.

 

mine had a little bow, but not enough to bother me honestly.

you could probably use the low setting of a heat gun if you really wanted to. But im leaving mine alone

 

I saw another post where someone used some non-skid tape from Home Depot. Looked like it belonged there.

 

Finally installed my Prinsu

 

Good looking truck - Is it lifted? From that angle, looks like it.

 

thanks man. It is.

running fox 2.0’s with back resis. Pushed it to a 3” lift with Icon DJ UCA’s and pro comp leaf to level out (will upgrade that in time). Here it is next to a stock sport.

 

Damn, that's nice. I've been contemplating 2 or 3 inch lift, but the kits I've seen for 2 are mostly just blocks and I'd rather just do it right with the correct setup. Besides, mines an SR5, so the stock setup feels weak/bouncy.

 

Took it to SEMA

 

Nice Rob!

Any chance you can post some SEMA photos in the SEMA thread over here? All things cool are welcome

 

I got mine from clazzio as well and initially tapped into the TAIL fuse for the illumination wire as well but my seats never warmed up unless I had the lights on.

 

Did you ever tap into a different fuse? my seats warm up but not very fast and definitely not extremely warm. From the way everyone talks about these kits I would think that they heat up insanely fast and warm.

 

I did. I don't remember which one it was now but mine heat up rather quickly, not super quick but they do get very warm. After a few minutes at 5 I have to turn them down.

 

Welcome to the club: https://www.tacomaworld.com/threads/the-number-81.534892/

John

 

There's a truck in this pic? Where?