1st Gen Lunchtable Thread - General Discussion

The old one

 

M10x1.25 sounds right. Here da part #

 

Don't buy a car from a dealer on a holiday; you'll just pay the same but wait 3 times as long as you normally would.

 

FTFY

 

Now that doesn't make complete sense.

 

What?

 

Damn, thank you

 

It's been a year and a shit ton of repairs. If I hadn't gotten a new job making more monies I would probably still be in the driveway breaking my frozen fingers into nubs trying to fix it but alas there is no need

 

I know I'm forgetting things too

• Fuel pressure regulator
  
  
• Brand new Garret turbo
  
  
• Brand new turbo up pipe
  
  
• Brand new Oil Cooler
  
  
• New Aluminum cold side charge air cooler pipe and silicon boots
  
  
• New front end parts: shocks, sway bar bushings, ball joints, tie rod ends
  
  
• New tires
  
  
• Aftermarket Aluminum radiator
  
  
• New starter
  
  
• New Camshaft position sensor, injector pressure regulator valve, injection control pressure sensor, crankshaft position sensor
  
  
• New 08 and up power mirrors
  
  
• Both batteries replaced

 

And I'm driving about 3500+ miles a month so I appreciate the comforts of the new truck.

Though I miss the sound of the old truck. It is a lot of fun to drive with the +190hp custom race tune I have too. Buddy's truck put down 440whp/770 ftlb torque with the same setup on a dyno.

 

Dayum.... That much at the wheels? This was which powerstroke?

 

Damn that's a lot of driving...for work?

 

2004 6.0l, same truck I have

 

most of it... my commute is 110 mi round trip


and the GF lives 120 mi away

 

and denver is a huge city so errands add miles too

 

Trying to figure out some winter projects here.

Who was it that did the washer reservoir with ABS pipe and an eBay or Amazon pump? Is there a write up?

The only thing I rub is the damn corner of the reservoir (mostly right there at the plug). Looking for ideas on how to alleviate that.

 

do you have cruise? if not there's a plug and play factory res that goes on the inside of the pass fender where the cruise module would be

 

Unfortunately I do have cruise... and I had to move it forward towards the intake because I shoved a battery on that side too. lol

 

I think @Blackdawg did the pvc thing. But I would take it to the other thread. He doesnt come in here much haha.

 

I asked over there to lol... figured you guys over here are always talkin, so I might get answer faster.