Question on wiring AEM UEGO WB into MAPECU3

Anyone have knowledge of this? I have tried to search for the answer via Google and can't find anything related to mapecu3 config specifically. My shop has everything out and is trying to wire it in so I can log with it through mapcal. They are stumped. Anyone?

Also, if I am going this route do I need the AFR calibrator or is that just an option to make it easier?

 

The white wire is the AFR signal out-put, connect it to MapECU Yellow wire and select the right input in the mapecu software for o2 sensor.

Not to be a willy nilly, the shop doing the install has 0 experience with this kinda stuff.. this sorta concern would cause me to worry.

 

Thank you. They have the instructions there with them. Kind of surprised they didn't see this. Hopefully they put it in properly. Fingers crossed.

 

company's make a plug-n-play harness for these piggy backs..

 

I will have to check this out. What are the company names if you don't mind? I am kinda green on all this stuff.

 

Also, the shop is good. They installed my supercharger kit. They just haven't done much with the ECU itself. I trust them.

 

https://www.mapecu.com/2014/05/plug-and-play-harness/

 

My Tacoma isn't listed there.

 

They got it in. I think they called Gadget and got the clarification they needed.