1st Gen Lunchtable Thread - General Discussion

But what kinda chooch factor is the skookum?

 

is that a parody of something?

 

Completely real, GE made the first model in 1962.

 

Of course, what kind of amateur pontificator hasn't heard of the turbo encabulator?

https://youtu.be/Ac7G7xOG2Ag

 

I didn’t think it looked that bad

 

What are you talking about, how do you synchronize your cardinal grammeters without encountering sinusoidal repleneration?

 

Doesn't cost much to lose something you don't need

 

Need to play with the stock driveshaft to see if it has enough slip for me to push the rear axle back an inch

 

I was stating my opinion, not asking for yours

 

I bet both of these guys could slay the whole modern major general speech

 

Thanks, now that's stuck in my head.

 

For the record. Chasis Unlimited is a legit shop and cool guys. That's where I got the bushings, bushing tabs, wheel carrier plate and DOM tubing for my rear bumper and swing out.

Again... cool, decent, dudes.

Not sure about their front bumper. I've never seen it in person. A friend of mine has seen one and says it protrudes out from the front of the truck more than he liked.

 

Wonder how it compares to the trial gear bumper. Mine poked out quite a bit.

they need to fix their add on eBay, as seen above, it looks like ass shit

 

My buddy, that said the bumper protruded from the front of the truck more than he liked... has a trail gear bumper on his 1st gen. If that means anything.

 

Oh.



still in for more pictures of the one @Speedytech7 posted

 

Thanks for the reminder, I'm going to call them tomorrow. And if they send me a couple pictures before I get off work and it doesn't look terrible I'll just go down there and buy it

 

How far of a drive is it?

 

An hour and a half. It's a very pleasant drive though. It's 100% rural in between the two cities. Just threw a whole bunch of rolling hills of grain and rivers.

 

Might hit ya up mid January, maybe

 

Feels good to have my garage back!