What Winch Did You have Hidden?

Yes sir, they charge an extra $100 I think for custom work. Just email them what you want and they can try to make it work We had to play with this one a bit to get it to work with the TSS

 

Sweet! Thanks for the info!

 

Are you able to reach in there to put it into free spool?

 

I have a 9500lbs superwinch with synthetic line. Sits inside my @demello bumper. I was able to move the control box up behind the passenger headlight with a custom bracket and then routed the handheld controller connection and a momentary switch to inside the cab. Unfortunately I don't have any good picture on me so I'm really not helping...

 

yes, I could easily reach down between the grille and radiator to turn the mechanical clutch lever. the biggest issue is having to open the hood every time you want to utilize the winch. I would pop the hood then lower it without latching until I was done using the winch.

 

Warn bumper and the Warn VR10 w/synthetic...

 

What is your suspension set up for the front?

 

You guys installing your own winches are some bad ass motherfuckers!!

 

Grossomotto do you have a install video or step instructions? nice job!

 

I have OME Nitrochargers and the 2888's.

 

I am doing the same. How much lift did it give you? Thanks!

 

SEXY

 

No install video, but it’s pretty easy even by yourself. Use a floor jack on wheels makes it much easier.

You can install a winch later, just take out the grill.

 

any cutting?

 

I did the SDHQ hidden mount with the Warn Zeon 10S, couldn't be happier. I went slow on the install, stretched it out over 1 evening and finished up the next day. Only addition I'm making is adding an On/Off switch to kill the power to the winch when not in use. I'm going to use the Blue Sea Systems HD-Series Heavy Duty Battery Switch since it is rated for 600 amps continuous (winch draws 435 if I remember correctly). I'm in process of 3D printing a mount for the driver's side fender bolt holes now. Hopefully the test print piece is good to go without any changes, takes forever to print...

 

No cutting just a lot of wiggling

 

I'm really liking the SDHQ hidden mount

 

Bro that thing is sick. I'm looking at them now and they look hecka expensive.

 

Settled on 2 1/2" and 33's.

 

Thanks!! I think so too