1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Home Improvement Today?

Discussion in 'Garage / Workshop' started by Hotdog, Jul 28, 2008.

  1. Dec 1, 2019 at 6:46 PM
    shane100700

    shane100700 Bed, Bath & Beyond Crawler

    Joined:
    Jun 1, 2011
    Member:
    #57578
    Messages:
    7,012
    Gender:
    Male
    Montana
    Vehicle:
    2019 DCSB, OR
    Rocket Boosters
    Shouldn't, not a plumber but replaced several over the years and never had an issue. I make it a habit to change all the pipe from the wall to the sink or at least rinse it and run some paper towels through them to clear the scum.
     
    wilcam47 and T4RFTMFW[QUOTED] like this.
  2. Dec 1, 2019 at 6:50 PM
    T4RFTMFW

    T4RFTMFW Well-Known Member

    Joined:
    Jul 23, 2014
    Member:
    #134525
    Messages:
    69,788
    For sure! I think I’m going to replace from the trap to the sink and replace the air gap as well.

    Part of me wants to just toss a new disposal in but I don’t have a real need to and I don’t plan on being in the house any longer than I have to.
     
    robssol, wilcam47 and shane100700 like this.
  3. Dec 1, 2019 at 6:55 PM
    theesotericone

    theesotericone Well-Known Member

    Joined:
    Jul 27, 2018
    Member:
    #260800
    Messages:
    12,341
    Gender:
    Male
    Bishop CA
    You'll need some plumbers putty to set the drain. You'll also have to re-use the disposal flange which will be on the old drain.
     
  4. Dec 1, 2019 at 7:01 PM
    shane100700

    shane100700 Bed, Bath & Beyond Crawler

    Joined:
    Jun 1, 2011
    Member:
    #57578
    Messages:
    7,012
    Gender:
    Male
    Montana
    Vehicle:
    2019 DCSB, OR
    Rocket Boosters
    That makes sense. Wait for your forever house to get that kind of stuff. We’re in ours now and buy stuff with the lowest Db ratings we can find.

    Most sink swaps are pretty simple though. Just knowing that it’s an over counter sink, use some putty or silicone (more common these days) under the sink and for the drain. Don’t rely on just the rubber seal if it came with one. Then of course, let it set and test the seals with a little water before full use.
     
    T4RFTMFW[QUOTED] likes this.
  5. Dec 2, 2019 at 9:20 PM
    wilcam47

    wilcam47 Keep on keeping on!

    Joined:
    Jan 27, 2016
    Member:
    #176243
    Messages:
    54,357
    Gender:
    Male
    First Name:
    Will
    Bourbon state
    I think they rtv under the sink edge also? Just make sure you connect back cold to cold and hot to hot...;) ask me why...;)
     
  6. Dec 2, 2019 at 9:29 PM
    T4RFTMFW

    T4RFTMFW Well-Known Member

    Joined:
    Jul 23, 2014
    Member:
    #134525
    Messages:
    69,788
    Definitely going to run some silicone underneath the sink, I have 3 young kids so splashing is real and I don’t want dirty water coming down into the cabinet. :D
     
    shakerhood, shane100700 and wilcam47 like this.
  7. Dec 2, 2019 at 10:12 PM
    GHOST SHIP

    GHOST SHIP hates you.

    Joined:
    Mar 9, 2015
    Member:
    #150537
    Messages:
    22,399
    First Name:
    GHOST
    A trick I learned to laying a clean bead under top mounted sinks is to dry fit the sink, then mask off the perimeter with painters tape. Then when you’re ready to set the sink, lay the silicone bead on the countertop just inboard of the tape line. As you press the sink down into place, a little silicone should squish out. Once you bolt everything down, you can pull the tape and reveal a clean silicone line with little to no cleanup. The tape should have most of the excess silicone on it and if you pull up and away from the sink there shouldn’t be much on the surface of the sink.
     
    rob1208, robssol, shane100700 and 6 others like this.
  8. Dec 3, 2019 at 5:39 AM
    98tacoma27

    98tacoma27 is going full "SANDWICH" Moderator

    Joined:
    Dec 18, 2008
    Member:
    #11714
    Messages:
    67,858
    Gender:
    Male
    First Name:
    Ben
    Not Beech Creek
    Vehicle:
    05 Tundra SR5 (+295k AND COUNTING), 2006 F350 King Ranch 6.0L
    Some stuff. Not a lot, just some.
    I was taught to use plumbers putty under the sink edge as well, not silicone.
     
    Kolunatic, shakerhood and Slashaar like this.
  9. Dec 3, 2019 at 7:59 AM
    T4RFTMFW

    T4RFTMFW Well-Known Member

    Joined:
    Jul 23, 2014
    Member:
    #134525
    Messages:
    69,788
    Is that for ease of replacement later down the road?
     
    wilcam47 and robssol like this.
  10. Dec 3, 2019 at 8:07 AM
    98tacoma27

    98tacoma27 is going full "SANDWICH" Moderator

    Joined:
    Dec 18, 2008
    Member:
    #11714
    Messages:
    67,858
    Gender:
    Male
    First Name:
    Ben
    Not Beech Creek
    Vehicle:
    05 Tundra SR5 (+295k AND COUNTING), 2006 F350 King Ranch 6.0L
    Some stuff. Not a lot, just some.
    I believe so. Easier cleanup as well. I don't suppose either choice is wrong though.
     
  11. Dec 3, 2019 at 5:25 PM
    shane100700

    shane100700 Bed, Bath & Beyond Crawler

    Joined:
    Jun 1, 2011
    Member:
    #57578
    Messages:
    7,012
    Gender:
    Male
    Montana
    Vehicle:
    2019 DCSB, OR
    Rocket Boosters
    When I did one recently, I readdressed this to see which was “recommended.” Both were about equally expressed.

    I will say the previous owner used putty in our bathroom. Under counter sinks, natural stone. The putty cracks and breaks off inside the sink from time to time. Also wasn’t able to remove it all when I replaced the faucets. I did read not to use putty on natural stone, and this is just my limited experiences with it. Not a fan though.
     
    wilcam47 likes this.
  12. Dec 3, 2019 at 5:27 PM
    98tacoma27

    98tacoma27 is going full "SANDWICH" Moderator

    Joined:
    Dec 18, 2008
    Member:
    #11714
    Messages:
    67,858
    Gender:
    Male
    First Name:
    Ben
    Not Beech Creek
    Vehicle:
    05 Tundra SR5 (+295k AND COUNTING), 2006 F350 King Ranch 6.0L
    Some stuff. Not a lot, just some.
    I've read not to use it on granite as it will stain it. There is a version that you can use that will not stain.
     
  13. Dec 3, 2019 at 5:49 PM
    shane100700

    shane100700 Bed, Bath & Beyond Crawler

    Joined:
    Jun 1, 2011
    Member:
    #57578
    Messages:
    7,012
    Gender:
    Male
    Montana
    Vehicle:
    2019 DCSB, OR
    Rocket Boosters
    I’ve never understood the love for granite, too much of a pain in the ass if you ask me. Next counters we do will be quartz. It’s butcher block now, that sucks too. Looks good but scratches and dents too easy.
     
    wilcam47, robssol and theesotericone like this.
  14. Dec 3, 2019 at 5:52 PM
    theesotericone

    theesotericone Well-Known Member

    Joined:
    Jul 27, 2018
    Member:
    #260800
    Messages:
    12,341
    Gender:
    Male
    Bishop CA
    Granites been around a whole lot longer then engineered quartz. It's better looking and used to be more expensive. Since quartz has really taken off in the last 10 years granite can actually be cheaper then quartz currently. I agree with you though that quartz is a superior product for kitchens and baths. It's why it will be going in my kitchen remodel. First, I have to win that argument with my wife. She still wants granite. lol
     
    shane100700[QUOTED] and buyobuyo like this.
  15. Dec 3, 2019 at 6:14 PM
    shane100700

    shane100700 Bed, Bath & Beyond Crawler

    Joined:
    Jun 1, 2011
    Member:
    #57578
    Messages:
    7,012
    Gender:
    Male
    Montana
    Vehicle:
    2019 DCSB, OR
    Rocket Boosters
    Luckily mine wants quartz more then I do.
     
  16. Dec 3, 2019 at 6:17 PM
    98tacoma27

    98tacoma27 is going full "SANDWICH" Moderator

    Joined:
    Dec 18, 2008
    Member:
    #11714
    Messages:
    67,858
    Gender:
    Male
    First Name:
    Ben
    Not Beech Creek
    Vehicle:
    05 Tundra SR5 (+295k AND COUNTING), 2006 F350 King Ranch 6.0L
    Some stuff. Not a lot, just some.
    We just got granite... And I can never tell if it's clean.
     
    shane100700 likes this.
  17. Dec 3, 2019 at 6:19 PM
    shane100700

    shane100700 Bed, Bath & Beyond Crawler

    Joined:
    Jun 1, 2011
    Member:
    #57578
    Messages:
    7,012
    Gender:
    Male
    Montana
    Vehicle:
    2019 DCSB, OR
    Rocket Boosters
    show off
     
  18. Dec 3, 2019 at 6:21 PM
    98tacoma27

    98tacoma27 is going full "SANDWICH" Moderator

    Joined:
    Dec 18, 2008
    Member:
    #11714
    Messages:
    67,858
    Gender:
    Male
    First Name:
    Ben
    Not Beech Creek
    Vehicle:
    05 Tundra SR5 (+295k AND COUNTING), 2006 F350 King Ranch 6.0L
    Some stuff. Not a lot, just some.
    :notsure: I hate the formica particle board crap. The kitchen was due for a remodel. Knotty pine cabinets. The knots lined up to look like faces throughout the cabinets. Freaky. Mid century crap. It's her kitchen anyway. I was just the labor.
     
    robssol and shane100700[QUOTED] like this.
  19. Dec 3, 2019 at 6:24 PM
    shane100700

    shane100700 Bed, Bath & Beyond Crawler

    Joined:
    Jun 1, 2011
    Member:
    #57578
    Messages:
    7,012
    Gender:
    Male
    Montana
    Vehicle:
    2019 DCSB, OR
    Rocket Boosters
    Yeah 100% agree on the Formica, good for the garage cat box but not a fan in the kitchen or bathrooms. Although what they have now is much better looking then what was out 15-20 years ago.
     
    98tacoma27[QUOTED] likes this.
  20. Dec 3, 2019 at 8:03 PM
    T4RFTMFW

    T4RFTMFW Well-Known Member

    Joined:
    Jul 23, 2014
    Member:
    #134525
    Messages:
    69,788
    Tell her it’s granite that looks like quartz.

    Then enjoy a beer.
     

Products Discussed in

To Top