Ditch light installation/firewall question

Team,

Any chance someone could take a picture of where I should go through the firewall at on a 2020 Tacoma? Never done this before and would like to do it properly. A diagram, anything would help.

Thank you,

Dan

 

https://www.youtube.com/watch?v=78KPwrBwddI

the hole is pretty tight especially if it's your first time but don't worry, just do it nice and slow and you will be able to penetrate.

 

Thanks for the prompt response. If I am going from the engine compartment in, any idea where I start?

Is that right below the white clear spot where I go through?

 

That's it. I put a cable fisher through it, taped my wire to that and pulled it back through.

 

OP, don't cut the seal. There's a nipple underneath to cut.

you can also run the wire right next to the hood release cable. It's the blue disk with black tube...
You're not running a welding cable for the ditchlights, are you?

 

Thank you. Ditch lights installed.

 

Show us the carnage...

 

Tell me more about that nipple please

 

Passenger's side you have two, no need to feel the nipple on the driver's side...

 

There's a rubber plug with two nipples on the passenger side. If you cut the tips off, you can run wires straight through to the interior. I did that for my CB radio.

 

My pic didn't show?

 

That's what she said

 

Here is the end result. Thanks for everyone's assistance.

 

Post some output pics!

 

I was talking about the violated wire bundle seal...

 

Really didn't turn out that bad. Will get pics during daylight hours.

 

Well gd dan

 

The comment I scrolled for, and wasn't disappointed.

 

So others don't duplicate the carnage...
https://www.youtube.com/watch?v=RUiKfNhCyuA

 

Its really hard to get a solid picture of the work performed but it works and minimal hole created.