San Antonio

I've been breaking my truck wheeling it hard. Just replaced my 2nd driveshaft with a 1-piece today.

 

Nice
Where from?

 

Tom Woods. I ordered it last Friday.

 

Cool so we don’t have to give measurements anymore?

 

I only had to figure out which flange and the length from one flange to the other. In my case it was the T4 flange and flange-to-flange distance was 68 and 11/32".

 

You gonna do the Clutchmasters one?

Been good, just sick as a dog lately. Not much new going on other than the usual!

 

Looks great man! Cant wait to hear what you think once you take her for a spin

 

I've put nearly 10 miles on it and took it up to 88 mph. Butter smooth. I'll upload pics of clearance when I'm done screwing around. Needless to say, it's a perfect fit and easier to handle than the stock one.

 

That fancy man you gonna have more horse powers now

 

Technically, yes. Less drivetrain loss with a single piece.

 

I still have a slight shudder from takeoff after every fix possible done

 

I wonder if a one piece shaft will get rid of driveline vibes I have if I does I'm gonna get one

 

If it was light weight aluminum one I could see that being a possibility cause I had a light weight shaft in my mustang it made a noticeable difference

 

Busy, not much on here during the day lately

Nice

 

Howdy sir! Well, today was kind of a pain - went to replace wall control and fan module which was full of wife's nicotine and only worked once a month for her. Just put in a standard switch, and a new controller with wireless. The fan was a pain, and I finally had to rig a wire hook, and cut wires short. Three hours later - no dimmer or light control - it's defective. So, it's hanging. Came out to get Amazon to replace it - no internet, AND no phone; check the modem - it's dead. It actually comes and goes, but had been off almost the whole time I was working. Get Spectrum coming tomorrow to replace the damn thing.
So, what was the next task? Install a new wireless printer! Apparently we shocked the modem into intermittent operation (since I am using it), and it's finally on the software install on the Mother machine. Later I might find out if it works!
Other than that, laying low, going to SATX C&C on the wrong Saturday, and not drinking because everyone insists I stop for the time being. Because I went to ER/Hospital and ended up with Congestive Heart Failure. Well, that was a surprise. I was there from Saturday before Thanksgiving until Tuesday, but I didn't die! The catheterization procedure showed 2 of 3 of my arteries were good, the third long gone but grew it's own replacement. Heart intact, but weak from congestion, so no other procedures were needed.
So, nothing much - hope to see you Saturday - been too long.

And a VERY IMPRESSED good on you for this! Sounds like great shit to me, and about time you got something good for your efforts! I knew I should catch up first before I asked how it was going - since I was off so long!

 

Howdy Kevin

 

Yes sir it’s getting better everyday

 

Yes it is

 

I'm loving the new driveshaft

Great news!

 

Dr. Kev2n!