1st Gen Lunchtable Thread - General Discussion

Florida...almost as bad,lol.

 

Wait.....is crow back?? How did that happen? Thought he went out in a blaze of glory?

 

Not a problem! Glad it's going to work out for you!

 

Only $19.99.

 

I know right where you were. Sportsmobile broke down there and had to be towed to Rock Springs. 4 hr wait for the tow truck.

 

I can take your pvs-14's? Off your hands

 

Hmmmm

 

Damn

 

Ew

 

A must have item for the home workshop..

 

Woah why ew? Billie’s suit the tundras needs just fine. Ome 885 coils for a 2nd gen taco and the bikes at the lowest setting will get my front level with the ass end

 

Ah what the heck, it's the holidays... Happy shopping (at least for the mount, can't do anything about the gauge prices) https://www.tacomaworld.com/threads...ge-mounts-group-buy-now-through-jan-5.644813/

 

No not that I just hate working with suspension pieces due to the forces there under.

 

This spring compressor makes it so you can’t fuck it up unless you try. The coils locked down with some beefy metal supports

 

I know I've worked with one before. But shit happens

 

I’ve had one bow out because it was under too much tension. But it held. You just don’t stand right in front of this thing and your relatively safe.

 

I've been hit by a torsion bar cause some kid cross threaded the bolt and I had to undo it cause he was to weak. Now that hurt lol

 

I don’t fuck with torsion bars if I don’t have to

 

Well it looks like the shop that pressed my hubs in pressed them a tad bit too far maybe? This might turn into a full on post because I don’t know how to proceed from here.

The CV is rubbing on the back of the hub. On the passenger side only. The CV is fully seated inside the differential so I doubt that’s the cause.

 

I don’t think it’s physically possible to press them in to far. But I’ve never pressed manual hubs together