What Have You Done To Your 3rd Gen Today?

I installed the OEM chrome exhaust tip which was under the tree on Christmas morning... I like the way it looks given the chrome bumper and the chrome trim Toyota places within the light housing. Not a chrome guy, but I think it looks good here.

 

Is your hood uneven? The right side appears higher than the left and isn't flush where it meets the grill. And as someone else mentioned you can move your lights down on the grill to make them symmetrical. My OCD wouldn't allow me to do it any other way, but that's me.

 

i like the matte black finish
thanks

 

It’s crazy you notice the hood, so long story short, it May be a little off. Just remember not to leave anything in the hood after closing it.... like wrenches. Going to see if I can do anything about it as of right now.

... had to edit this post, I just checked and it looks pretty flushed to me. Phewww** now back to work lol.

 

https://www.tacomaworld.com/threads/3rd-generation-matte-black-tacoma-hood-stripes.540878/

 

Omg!! Lol I just noticed it too...he really is OCD lol

 

Your lights look fine. They're what I'd call asymmetrically symmetrical.

 

Swapped out my halogens with these hikari led's this morning. Headlight housing is a little foggy but either way a lot brighter than the stock lights!

 

hey your hood's a little off..

 

Yea leaving things under the hood is never good. Been there done that. Glad it's flush. Now quit screwing around with your truck and get back to work.

 

Yes he is...lol

 

They come with locking screws that attach to the carpet for the passenger side. Works beautifully.

 

I attempted to install a magnet gun holder that I got for Christmas. First the 3M double sided tape that came with it didn't stick at all (even after cleaning the surface thoroughly with alcohol). Because it didn't come out past the rubber pad. Then I tried it with my own 3M tape. It held for about 4 trial pulls of my EDC handgun itself. So just took it off, not going to drill through the console to hold it into place. Guess I'll go with my original plan of putting on MOLLE console plates (I am OK with drilling and screwing them in.) But hey it's the thought that counts.

 

Picked up a tear drop trailer for the Taco to tow

 

Nice looking rig! Who makes this?

 

I bought it 2nd hand off of FB Marketplace. But its a company based in Florida called Tiny Trailer Co. They Rhino line all of their trailers it seems

 

Neat trailer. I think it is actually Tiny Camper Co: https://www.tinycampercompany.com/shop-1

 

Yea I think it looks fine too. What I don’t like is when all four lights are close togheter, doesn’t fill up the whole grille.

 

Here we go again... lol. Making me check it for the third time. I’ll check it again on break.

 

Black RTV adhesive works wonders. Gotta give it plenty to cure time. At least 24 hours. 48 is better.