TRD/ Magnuson 4.0 Supercharger Tips, Tricks, and Mods

so true. never seen a bunch of people that dont want to drive the speed limit. try that shit in atlanta and you will get ran the fuck over

 

Lol, sounds like you need to come to Montana.

 

But Montana drivers will at least show you the kindness of moving over and letting you pass in the left lane.

 

so true!

 

id love to.

 

Sure thing

 

ah ok, Robs note on the 1st page notes you will be cutting all day so had me thinking its going to take forever.

 

I used a ratchet on my snout cutter and it only took me 25-30 minutes. This was all done by hand. Add some WD-40 to it like @White lightning boosted mentioned, and things should go even quicker

 

ah got it. yah I have done the pinch welds already. Still need more room. Def tires play a role in it.

 

I would have to check but at around 65-70 mid 2000's sounds about right. At 75-80 its high 2000's maybe low 3000's.

 

If its that soft then my variable speed drill should work. I do not have an air tool. Seems like the cordless drill should work just start with some lower speeds.

 

cordless only, steady hand slowish speed. just take a little off at a time. its way easier than it sounds.

 

Yup, perfect.

 

https://youtu.be/68bfICvik7Y

 

Thanks for some reason I kept missing that video. What oil did you guys use when cutting?

 

Some drill bit oil @BillDaCat8 had in the garage I think

 

shit, any oil. olive oil may be fine.

 

I have a can of some aluminum specific cutting fluid that I’ve had for years. Although I don’t think it’s necessarily a “must have” For this operation.

Try this stuff.

$10 A9 04z-A-9 4 Oz Aluminum Cutting Fluid

https://www.amazon.com/A9-04z-Aluminum-Cutting-Fluid/dp/B0000DD2EX

 

Ooo... That's hot. I like that!

 

Anyone need a serpentine belt set? Accidentally ordered 2. Prob not worth it to send to back to Amazon since it was my bad.