Show me your knob.

$40 shipped if interested

 

Lucky 13

 

Hurst ball on a Core shifter with an extension. this is a sloppy temporary waiting on the custom Ti & Delrin hybrid job..

 

$30 now. Paper weight on desk lol

 

Custom made

 

Another from house of speed...

 

BRZ stock shift knob

 

Where did you get the grenade, do you know if it will work with a auto shifter?

 

Saved it from active duty time. I have seen them at surplus stores in GA as well (mostly the M67). It will take a bushing to fit. I used thick rubber.

 

So it was an active real grenade with inners removed making it anert?

 

It was real, in as far as that it was US govt issue. But it was a training "dummy" already holed so no combustion expansion could occur (inert). The spoon, striker, striker spring, primer, safety pin & ring, and fuse body were all complete. The fuze was removed and I popped the primer.
I utilized the hole for mounting via the heavy rubber bushing.

 

Very cool thank you for your service and the information

 

Gonna try this one out! Made from Delrin.
Might ditch the grommet later or snug the boot up to meet the shifter. We'll see.

 

You get your final knob in yet? Was curious to see yours.

 

not yet. no idea when, actually.

 

Anyone have a good link to heavy metal knobs? Tungsten maybe. Platinum too expensive. Plutonium a bit warm. Coated Lead? Copper or Nickel denser than Iron.

 

no but this one is 733g and that's a heavy one. i have a red one and used it for 2 years. https://anarchy-motive.com/products/6-speed-goliath

 

I noticed even with my Ti knob, the shifter rattles around significantly more than stock. Anyone know if this will cause premature (excessive) wear on the bushings, or transmission internals? I find I drive around with my hand lightly resting on the shifter most of the time so it's not so much of a problem. I imagine it would be even more pronounced with a heavier knob.

 

Oh baby!