What Have You Done To Your 3rd Gen Today?

I love your “Hello my name is” patch!

 

Awesome!

 

I love California

 

Put my lift leveling kit in yesterday as well as my new wherls

 

@krn_taco90
So the connections for the dome lights are in back of these 2 switch's?.
Do you remember which color is the + wire? Blue or yellow?
Thanks

 

Welcome to the forum from Eastern North Carolina.

In that picture, the front end is higher than the rear.

BTW, them is some nice WHERLS.

 

That's the aluminum stock from Home Depot? I'm using the same thing.

 

I got the Tyger vinyl tri fold from Amazon, the 5ft was on sale for 160$.

 

Looking good.
Welcome to TW Bud!

 

Welcome to the herd!

 

As I have said before, I like California in spite of all of it's faults.

 

If you don't mind me asking, how much was the SpartanX hood scoop light? I don't have instagram and he hasn't answered my email. Thx

 

thanks much. Not too sure why it looks that way. It actually does sit level. It’s at the parking lot at church so maybe it’s the way it’s parked

 

As a resident of California, I love the state, but I hate the politicians (D) and their policies

 

Two fiddy shipped in the pre-sale run before Christmas. Just got the standard light, they're is an upgraded stealth version where the light is, I am guessing, covered over with a grey scrim so it does not show the reflectors all the time

 

I believe he is talking about the A pillar. The wires go into the white plug in the picture. The blue wire is the positive. It's where I tapped in for my puddle lights.

 

Gotcha. Thanks

 

Just add little bacon grease and char on the grill. Still won't help cali..... I don't think....

Sorry. Lol.

 

They are behind the drivers side kick panel. Search for instructions for installing factory bed lights for 2016-2019. It with show you which ones to tie in to. Edit. Here it is

 

I had the same issue when I wired my light bar. The switch stayed illuminated all the time. If I recall I switched the green wire and the red 1 wire and that resolved it. I then tapped into the fuse box to my tail lights with the red 2 wire so that the switch would illuminate when the dash lights are on like all of the other switches. Post 263 and 264 should help.

https://www.tacomaworld.com/threads/ken-the-electrical-guy-q-n-a.632969/page-14#post-22298402