What Have You Done To Your 3rd Gen Today?

They did. This started the fuel pump recall.

 

Where did you purchase the skid plate? What is is made with?

 

My Spiker hood struts shipped!


Should I use the Taco lean spacer with those?

 

Thanks again to Sergio (Ghost Ship)for the RTT Bars. The vision is getting closer to fruition. Just received my RTT yesterday and installed it late last night. Perfect fit! I love the clean lines of the bars and easy attachment to my bed. Super simple to take off and on. For those of you out there who are deciding to get a RTT, I am impressed with the quality and comfort of the Smittybilt for the price ($800). Easy set up, and I was able to lift and install it on my own.
Also received my ditch lights and 20” light bar that will be installed once my CBI Front Bumper comes in. CBI sure does have LONG lead times!

 

Is there a way to tone down the whole tail light from top to bottom? Not too smoked and look like a weird black and red I see on ricer cars, but more like the 2018 lamps.

 

Hit 50k. No issues except a defective 4WD actuator replaced under warranty at 10k miles.

 

Ooo I kinda want a traeger but I don't use my charcoal grill that much as it is.

 

Found these bedrail spacers on thingiverse and had my buddy print me up a pair. Painted them black and got it all installed today. This should help keep water from getting in the bed around those gaps toyota graciously left at the front of the bed.

I'll likely still throw some silicone around the edges there where the bedrail meets the sides of the bed as well, but these spacers are a perfect fit!

 

These are aluminum skids (powder coated) from here. The skid trilogy took some gentle persuasion to install on the truck. I may end up reworking the transfer case skid/mid skid connection as it hangs a little low. Definitely not a fast install.

 

It should function like a standard turn signal bulb with no input to the drl. They also have some turn signals on closeout right now for like 40 bucks for the pair of you don't want to go all out.

As for the dim wire I believe there is just one harness. There is a wire that comes off the bulb housing with a circular connector that would connect to the harness and a wire off that that could either be spliced or you can build your own harness with the dim DRL WIRE.

 

Vinyl is done. Yeah, Punisher is common, and thin blue line, but I still dig both!

 

New shoes! These really ride nice and quite! Look great too!

 

Got my new to me 3TPAM installed yesterday.

 

Any chance you still have the file or link???

 

https://www.thingiverse.com/thing:3941516/

 

Since you installed it, have you notice any water leak inside the bed? I have been looking for a solution to keep the water out from that end. I got a tonneau cover on and no water gets inside the bed except those 2 end. Would your friend be willing to print another set? If so, how much would he be charging?

 

Shot you a message.
What tonneau cover do you have?

 

Unfortunately I just installed it today so I'll have to wait and see. Also, I live in Colorado and it doesn't rain here. I don't think it's rained here in 2 months or more so it may be a while before I get a chance to see how watertight it is.

I can message my buddy and see if he'd be willing to print another set.

 

I just bought those the other day because I was looking for a place to put my XDS also. Does it seem sturdy enough with just the 3 screws drilled into the thin plastic? I was thinking about taking the console apart to add a washer and nut to the other side.

 

Yes please. Thanks.