TACO GARAGE - Any camera - anytime, plug and play, steering wheel controlled. 2020!

@FreshMexicanTaco
What’s the plan with usps? Do you have another you could send out?

 

I used the Natika camera.
The two wires from the camera end are not used.
The red wire by the RCA plug is connected to the red 12+ wire on the module harness. That's it.

Cheers

 

Thanks mate, just what I needed to know. Can't wait till the camera gets here.

 

If anyone is wondering if you need to trim part of the grill near the TSS to get the camera to center, you do not need to cut it.

I have mine right next to the area where people are trimming, but it could've gone even more away from it, for the camera to truly center on-screen (it's off by a few mm)

I hope these pictures will explain better than I did...

Nakita camera with medium shim

 

Hi, I pm'd you @FreshMexicanTaco

 

Yeah I saw some just wad up the long red/black wiring from the camera end and zip tie and tuck away. I just cut that crap completely off and tossed it.

 

@Clarky4×4

 

Got mine!! Thank you!!!

 

I installed all of the HU harnesses and confirmed that it will work on my 2018 Tundra since i do have an entune HU. I have not ran the front camera or hooked it up however it will switch over when the hold button is double tapped. When pressing the down button it will kick on the factory rear camera. I would consider this a partial install, but confirmed basic function.

What i am curious about is that there are (2) RCA plugs on the kit harness. The factory rear camera does not use the kit harness, so does that mean i can run (3) cameras total?

 

For those that are using the Natika front camera, which shim did you guys use to get the front bumper just in view of the camera?

Thanks!

 

I used largest and smallest, that is with Pro Grill

 

@JIMMEISTER I have the pro grille and put it in the dead center if the grille with the TSS system. Mounted great and did not use a shim. The front bumper is barely in view.

 

Hey @FreshMexicanTaco you missed my Order for the Groupbuy Post#307 ordered Jan 4th.
FYI @bonifacio is in the same boat as me post#304

 

1/4.

Also messaged @FreshMexicanTaco, no response.

 

Mine apparently was lost By the shipper. No response from the freshmexicantaco.

Hmm. Hope everything is ok. Also have not heard from him in regards in my lost order.

 

We have been very busy but I’m going through pms right now, I will take care of all of you, both the refunds and the missing cam.

 

Thank you!

Everything has been resolved.

 

Which shim did you use?

 

The medium one.

 

So basically with the Nakita, cut the green for no parking lines and the white since it's going in the front?

Just triple checking because I get cut happy.