What Have You Done To Your 3rd Gen Today?

i am.

 

Had to replace my cupholder trim with the Meso trim. The previous one I had installed wasn't sticking anymore. Both were cement but obviously very different shades.

Don't mind the mess

 

Looks like you did the top row. Take much cutting? Ooops - I finally caught up in the thread and saw your comment above about using the Dremel. I have a set...that will go on my AG Pro when it arrives later next month. Not sure if I want to put them on the top row or center

 

Behind the rear seat second battery installed (new AGM shows up tomorrow). Running my bed outlets, amp and the outlets in my center console off of this so some things have constant power without worry about the starting battery

 

Picked up some S1’s. Going to try them out as ditch lights. Bought the wide cornering pattern. What are your thoughts on running them on separate switches? It’s pre wired to run both lights to one switch. But, could see the possibility of running just the passenger side as you went down the road to light up the ditch (for deer) while not having your driver side on and bothering oncoming traffic. Thoughts?

 

I was going center but the lights were too small they were just falling off! i decided to bite the bullet and try the top row using a dremel w a small stone tip. it took a few mins and even being careful i nicked the bottom part a few times! lights cover it so you can't really see it! i was hesitant bc i can't just buy this grille with camera from what i have read lol

 

Hope you don't smoke.

 

IMO, I don't think having a wet cell battery in the cab is a good idea. There is plenty of room under the hood for it.

 

@Jonathan121
After hearing that it’s a couple grand I wrap your entire truck I was arrogant enough to wrap the whole damn thing! It’s an ENORMOUS pain in the ass. I’m pretty capable of most things with some instruction but you watch these guys on YouTube wrap a door in 10 minutes. Then you do it and are cussing the world after four hours!
Ironically the mirrors were the hardest part by far! I ended up just pastidipping the mirrors and a few other offs and ends. Turned out great but took damn near a week!

 

TMI, TMI!!!!

 

looking at the reflection of the guy taking the pic. I believe it. Lol

 

Oooooo . . . BOOGEYMAN !!!

 

Stay strong me too! Before I had my surgery (my excuse and I’m sticking by it) I added a few lbs I’m shedding with caloric deprivation. I claim to be saving $ as well so I can buy more parts of course. Funny how quickly not eating a few doughnuts adds up to a “budget” for mods.

 

Put on RRW RR5-v’s 16x8 -25mm. Also plastidip’d grill bezel and emblems (still gotta clean the residue)

 

Dropped it off at the dealership to replace my leaking third brake light seal great $400 to spend, still gotta figure out how to fix the headliner and potential mold

 

Recipe ?

 

Doughnuts I can live without but the beer?

 

Take a pic of it tomorrow. A load of ingredients in it, would take me most of the night for me to text.
I have it typed out and stored on my computer. Made some copies for the hardbodies at work that wanted to drop some weight fast. Loads of protein and good carbs.

 

I've been trying to make good cabbage soup for years and have never been able to get it quite right.

 

notice i had the same question a page back. not sure why but I've always loved whatever version i find.