San Antonio

Yes, little cooler than expected, 29 here.

 

Not that bad here

 

No wind so it feels decent out.

 

May be good day to burn

 

Maybe, got to do a couple things for the wife this morning, put out some fertilizer and then go to gun club meeting today. Nothing too difficult today.

 

I have to pull more wire to feel better. Up and down ladder and stairs kicked my butt

 

Ya that stuff can get to ya, once you get it all pulled then you can start terminating it all. Got the main runs to the panel yet?

 

Pulled 9 circuits from panel
Many more to go
Then the big stuff

 

Cool

So the mains, path built and wire ready to pull in?

 

Yea drilled holes in main path but they way I built last 2’ of walls allows me to a path for wires without drilling.

 

Cool, since you panel is going to be outside I would recommend that you use no-ox on all of the copper to the buss terminals to ensure there is no issues down the road.

 

Electrical grease?

 

Yes, kinda messy but helps eliminate any potential rust issues, used between unlike metals.

 

Gotcha
Thanks
Was thinking of getting electrician do panel?
But will make a note inside box.
I’m just writing on wall the number sequence and on wires and boxes

 

Don't need an electrician to do the panel, you should be able to do it.

 

Cool
I’ll take a peak when I’m done. And get better strippers etc

 

Ya get you a good set of kliens, mine have held up well over the years.

 

I still need to research the big wires needed. And do ceiling fans need 3 hot from switch?

 

two hots, a ground and neutral, so a 4 wire run will work. Do you want to control the lights from two parts of the room, if so you will need a 3way switch to do that.

 

Yea so 12/3
One place I want a 3 way but haven’t found how to do yet