1st Gen Lunchtable Thread - General Discussion

Thanks. It has been a few years. Have had a lot to deal with since; obviously I wasn't in a good place to have allowed myself into that kind of relationship to begin with

 

PRENUP

 

Wonder how dead they are

 

What y’all doin with them taxes tho?

 

not sure.

24 ft gooseneck? Laser eye surgery? home repairs?

 

Gonna get some bad spots fixed on the paint of my truck. Rest will go into savings.

 

What taxes?

I'm holding off a bit until I have to pay; last year it was just shy of $7k...

 

what tax return

 

Is this a cry for help

 

Said every hard working Californian

 

I'm still waiting on my EOY bonus; supposed to get paid by the end of this month

 

I have a 7x20 bumper pull hydraulic tilt with winch I have $8k in

 

sounds like a nice trailer

 

It’s a down2earth brand. They build good stuff.

 

I figure with a 24 foot deck I can still squeeze my tacoma and another rig on there if I did something like this over the goose...then I also am not stuck with a 30+ foot trailer if the GF and I split

 

My return will likely go into paying off the CC.

Hoping to keep a lil of it but we'll see if I can do it. Wanna get the spindles and finish the truck "for now"

 

Tilt has to be nice for dealing with loading cars and low clearance stuff like the 5 lug

 

Oh yeah even picking up cars like the Lincoln towncar when the rear bags go out

 

@NV.ENGINERD

The 8.4” Axle Shafts with ABS will work in an 8.0” E-Locker axle. HOWEVER! It is slightly too long. I tested if it would rub the spider gears, but it didn’t. You could probably run them, but I’d have a driveline shop cut it shorter and re-spline it.

8.4” NON-ABS axle shafts will not work. It must be ABS as all e-locker axles are equipped for ABS even if you don’t have it.

 

There are others way you can lose $5k in 5 minutes