Bent suspension

so you did jump it

 

Ahh!! And finally his integrity shows up. One of the folks always blaming shit on someone else. “Prove I did the damage” yep character shot to shit. That statement says a lot about you.

 

Save me 2600 bucks

 

Hay Op, just rip it all out and do a SAS with long travel Coil suspension.

 

Can you show us a picture of damaged/affected components?

 

If you are 4x4 the hub should bolt on.
The bearing is pressed on/in to the hub.
It much easier to buy the whole Hub/Bearing Assembly.
It’s held on by 4 bolts.
Then further by the big axle nut. (Only used on 4x4 trucks)

I’m not too familiar with the PreRunner or 5 lug truck.
Maybe they are “press in” but my hubs on my 4x4 bolts in.

Here is link to a guy on here that sell the assembly.
https://www.tacomaworld.com/threads/wheel-bearings-hubs-press-service-4x4-prerunner-nsk-koyo.537080/

The key to a good assembly is good bearings.
And a proper press.
Which isn’t really something easily done in a garage.

 

Dealerships aren't completely retarded, you think they are going to look at your truck with all these bent and broken parts and really say, yup just normal wear and tear here send it off for warranty.

 

Thank you TnShooter

 

That made me laugh whatstcp

 

Post a pic of your busted up shit.

 

Its still down at toyota

 

They'll let you take a picture still.

 

Hang on let me look through my phone i have couple

 

Yep, for insurance reasons.

 

I have some more bare with

 

Here another

 

Now were getting somewhere. Spindle is bent.

 

Also, did the dealer give you any paperwork that stated how they know what has failed or been damaged? Any alignment check numbers?

 

No nothing yet just gave me a price of 2600 so the warrabty people got sent today to see if it's covered or not