Rago Fabrication ARB Compressor Mount help

So the mount arrived but can anyone tell me how it goes together and mounts? I got 4 hex screws but only two places to put them in the rivnuts for the support leg. So then I thought maybe they are for mounting the compressor to the tray because they kinda fit- but that leaves me no hardware for connecting the support leg to the tray. Then two large bolts, those are obvious to me..except there are three large holes requiring big bolts. That leaves the hole on the support leg with no hardware.

just confused and haven’t seen a video or instructions on @ragofabrication site.
TIA

 

Seems simple to me, maybe you are overthinking it.

2 bolts for the fender, factory bolt for lower support, 2 hex screws for support..ARB provides the hardware for mounting.

 

Ok. Appreciate it. This leaves me with extra hex screws and washers. Had their only been two I’d be less confused. Swear.

thx

 

Maybe extras in case you lose them?! Idk

Maybe for other accessories?

 

could be. Also my compresspr didn’t have mounting screws so this is why I’m all confused. Less so with your help!

 

I can’t remember the hardware for the ARB I think they are M6x16.

 

Just to follow up I’m
Not completely retarded.

Missing the hardware that connects the support leg to the tray. Four hex bolts ARE for compressor mount. Then the two big bolts for the fender existing holes and foot uses factory bolt already there.so you were right but I’m also not dumb lmfao

 

Sounds good, so I was very unhelpful lol

 

Lmfao

 

Post pics pls

 

We got it squared away. They sent wrong/and not enough/correct hardware

 

Would still like to see completed install pics

 

I got the bracket and compressor mounted to it on my bench so far. Hope to finish the sPOD install this weekend and then the compressor install will be the last bit. Happy to share. PM and I can text them as well if that’s useful.

 

Pm was sent