1st Gen Lunchtable Thread - General Discussion

I can put manual hubs on the rear too... but that is the danger zone because I don't want people unlocking them on me for the lulz

 

It is

 

I'll take "Conversion Camp" for $500, Alex

 

How’s the barn search going

 

Got a line on 2 places. Going to look Friday.

 

That's a great way to do it, just need to machine a little design to go around the joint. Would be really easy to make an xbrace style one

 

Didnt they say that last time?

 

Means the axle shaft is separate from the hub

so yeah unbolt the axle and the hub is seperate from the diff youd just have a gaping hole gear lube can come out of and dirt can go in

 

What frame shop is this... i may end up there on the future if i keep the t4r

 

Also, the weight is supported by the hub instead of the axle shaft

 

The body shop got it as straight as they could with what they have.

it’s going to a shop that only
Does frames.

 

Frame shop around here is highway robbery. They wanted $200 for a 16x14 matted frame in Mahogany.

 

Found a bare frame in Mississippi . 2001 4x4 for $500.

 

Dibs on 10% of profits

 

1995-2004 Tacoma Fender Flare
https://classifieds.ksl.com/listing/59220070


who has a broken flare?

 

I fit my full size 285 in the stock location cutting the two tabs off that angle down in the rear (front would have made it touch the axle so left them on). Ruined my clearance a bit but was fine for the 6 months while I planned the swingout

Best pic below unfortunately. Also did an exhaust chop when installing the new suspension and purposefully kept it a little longer so the hot temp didnt affect the spare


I don't think a bigger tire would fit without rubbing the leafs

 

Bell housing on the 2.4 and 2.7 with a W59 4wd or 2wd are exactly the same. So you can use the one off the 2.4 and it bolts directly to the 4wd W59 or you can use the bellhousing off the 4wd W59 and it will bolt rite up to the 2.4. As for the axle find your self a 6lug axle the 2wd axle is only a 7.5 @Sperrunner has shafts and housings

 

A 10.5” wide tire will fit nicely then, neat.

 

I have a v6 a340f.

 

W59 output is not the same as a R151, right? or am I tripping?


asking because I am soon to own a very rare W59 transfer case clocking ring