1st Gen Lunchtable Thread - General Discussion

Did your dad discipline you by putting you on a shelf

 

You two get a room

 

Same goes for you, god knows it's a work out just getting you to stand up.

 

Yeah, especially with these weak ass insults y'all are tossing around like wet paper towels

 

too much BS for a BS thread?

 

now I get it

 

Yeah I didn't want to go ban-worthy

Keeping it PG and staying off of protected classes and the sort.

Speaking of, fuck I have to work

 

Fck this virus

 

you tell 'em jay

 

California needs shookup

 

In your neck of the woods, rust would do away with it like it does everything else right?

 

No, it's already in shambles

 

$131 for a new OEM servo motor. Might just get that instead of trying to fix what I have.

 

I fully expected 3.4 to take a crap before that

 

For the good of the country
Do wot my state does

 

Corn and beef is wot we do

 

And cousins

 

That would be done in Missouri
Not here in the red state
Husker red

 

Fixed

 

Before posting a new thread... Do any of you have link(s) on hand on the specifics on everything that should be done when installing extended travel coilovers up front? Is there a thread about coilovers like the "Towing Bible" that has actual concise and knowledgeable information?

I assume the following:

• Correct (longer) bump stops
• UCAs
• Alignment

From the install directions of the Bilstein 5100's, when using the tallest height, they specify removing the factory bump stop, installing spacers and then reinstalling. I wonder if having too short of bump stops and bottoming out is one of the causes of the strut towers to deform/crack/fail like @Squeaky Penguin and others have experienced...