Low profile bed side storage racks

I wanted to develop a setup that allows you to install a tonneau cover or overhead rack by not occupying the utli-tracks. It needed to be low profile, sturdy and didn't rust or dent. I also wanted a clean factory look. I came up with this molle rack. THe molle holes are a tad bigger than mil spec, this is so you can install your molle pouches vertical or horizontal. Pictured is my personal 3gen, i believe it should fit the same on the second if you have the utili-track :

It's made of UV stable 1/4" terpolymer plastic which is machined to 1/8" on top so it can fit under the side utili-tracks.
To install, remove your your utili-track and lay it on top of the molle panel, transfer the holes from the track to the panel. 10-15 min total install time.

If you prefer metal i can do it too.

First batch:
$200 for two
$125 for one
$20 to ship.

coupon code is corona

https://ogfab.com/products/og-tacoma-bed-sidewall-molle-rack

 

Subbed. I’m interested

 

Subbed

 

Subbed if shipping to Canada is possible.

 

Subbed. Rear panel?

 

Not a problem Eh.

 

I put the link up.

 

I can offer you the installed one pictured, its 3 weeks old, my prototype.

 

PM'ed

 

for which size bed? does generation matter?

 

My truck is a standard bed, 3gen. From the pix ive seen, the beds are the same with the exception of some access panels.

 

I have a MX4 tonneau cover that moved the side rails down about an inch. Do you make a shorter version (top trimmed off)?

 

I can machine an extra 1" off the top if that works? The material ia .25" thick, but i have about 1.25" on the top machined down to 1/8 so it fits under the rails, i can machine it 2.25" from the top if you like?

 

My 2nd gen has the smaller cubbie holes in that area. Any way if I measure them you can just cut out the extra length? Basically have a two piece for the one side?

 

Send me pix of what you got.

 

sub'd

 

This is the bedside on a 06 access cab. The cubbie hole is 9 13/16 inches length, that's the outer dimension of the lip. The lip starts about 20 3/8 inches from the front track screw

 

Is that cubby hole edge removable?

 

Give length so i can make two panels for you.

 

Roger, those were quick measurements at work. The cubbie itself is a separate module that pops out of a hole in the bed. I will get better measurements later today.