South Carolina BS thread under new MANAGEMENT and lives in SC

We were hitting a couple places with submerged cover and brush piles. Hair jigs and curly tails. The one i caught was in about 11ft of water right off of some reeds near the bank.

Water temp was in the low 60s.. i don't think they're quite on the banks yet, but they're probably in transition.

 

https://www.live5news.com/2020/03/22/large-police-presence-reported-johns-island-airport/

 

It’s about to go down! @ahspurlock fiddin’ to cut a big ole hole

 

He’s violating my hole

 

I still need to find a template solution for my Arb snorkel.

 

He using lube?

 

You can kinda make a template. Tape and mask up everything, then install the studs into the snorkel. Paint the tip of the studs with a marking paint and press it against the area you masked. It'll help if you have a buddy to look at the alignment while you hold it in place, that would help too. Then when you're drilling your holes, up-size by at least 5% to give you some wiggle room. It'll be covered by the snorkel anyway, so you wont see. Get yourself some larger fender washers if required to take up any excess in-case you got a little too heavy handed with the step bit. Finger tighten everything down, it'll let you adjust the fitment slightly to align with the A-pillar. Now you can install the upper bracket and mark those holes off the bracket. Measure thrice, cut once. Start with a smaller than required bit (or step-bit) and move up from there until you get the fitment you are looking for.

-J

 

nope

 

I've seen similar to that suggested before, and that would probably be my last resort. I'm going to try and remember to call ARB tomorrow since they won't reply to my emails. I've also read that they will send out a PDF version of the template that prints on a few 8.5x11 sheets, and you just have to match the pages up. The 1st gen version of that is available online, but not a 2nd gen.

 

Voila

 

Nice!

 

https://youtu.be/q0PBg_3iVBw

 

Somebody needs a tire swing out gate......Ready to go weld on hinge to your high clearance!!

 

If that was from yesterday, a plane went down killing the pilot. That's word on the street at least. It went down in the swamp and it took a while for responders to get to the site

 

Anybody running a CB antenna on the upper mounts of an ARB bumper?

 

Anyone have a set or bed bars for sale?

 

I ran one on my DV8. Got annoying after a awhile. I don’t see how the Aussies do it.

 

@ahspurlock does I think