Official* New England Buy/Sell Tacoma Marketplace

@RoNeil here are both things I was telling you about

 

Inbox for quickest response. Need gone. $200 Tw express welcome. Can deliver in 50 mi radius of Boston

 

This week I had a Leer 100R installed, so I am selling my Lomax tonneau tri-fold cover from my 2016 DCSB. I bought the cover in October and have not removed it from the truck until this week. Everything is 100% functional and the cover is on near new condition. There are some cosmetic scratches underneath that are from loading and unloading tools. On the top there is a scratch from a box bearing slid on it. There is NO discoloration and the cover is ugly functional. I will replace the D shaped rubber seal with a brand new seal upon request. These can be found online or at your local DIY stores for under $20.

I would prefer local pick up, I'm in the Providence area. I'm more than happy to drive a bit to meet up depending on the distance and will help install if needed, but agin, I'd prefer local pick up. LMK if you have any questions and thanks for looking. Asking $400, OBO.

 

SOLD

Just bought a 35mm socket, cotter pins and 3 jaw puller for front wheel bearing job. Selling them for $40 which is about 50% off.

 

Delete my friend before the ban hammer gets you.

 

As Rick mentioned, there is a post minimum to put something up for sale on Tacoma World. You must have a minimum of 50 posts in order to sell something, even if you joined more than 2 years ago. If you do not delete your sale thread then the moderators will help you delete it and give you a short vacation typically. Surf a few threads, visit a few builds, hand out a few compliments and you are over the 50 thread count and good to go. You are only 21 posts away so it should only take a couple days, if that.

 

Perfectly stated my friend

 

Sorry, I missed that.. my bad.

 

Just go back and delete it

 

Got it.

 

I’ve got a hitch mounted winch plate, oem all weather floor mats (dc), a fairlead block off plate, and a TRD third brake light cover for a second gen. If anyone’s interested best reasonable offer on all. Can PM pics if interested

 

No worries. Easy to miss and those of us that see it often point it out. We would rather you delete the post then get kicked off for a few days. That does not promote feelings of good will if that happens and we want you to feel welcome her and post more, not less.

 

I have 2018 TRD Sport cement grey OEM fender & bedsides (whole quarter panel not just fender flares) and rear bumper assembly for sale. Only 18K on them. No major dings, dents or scratches (some tiny scratches from off roading). The front plastic fender flare inside corner was trimmed to prevent tire rubbing (see pic). Any reasonable offer will be accepted.

 

You’re right, this forum helped me a lot with all the info, write-ups, etc... I’ll try my best to get more involved. Once again thanks.

 

Single Relentless Fab bed bar. Came as a set of 3 and I'm only running two this year. Powdercoated black. I believe it fits both second and third gens(has two different bolt slots). Sits 5" above the bed.
$50

 

WTB a few front end suspension pieces for my 2nd gen. Mainly looking for a passenger side spindle (with hub/bearing preferably) and a set of oem UCA's. Located in Greenfield MA area and willing to travel reasonable distance. Thanks!

P.S. If this is not allowed because of low post-count will delete. (Not sure because its WTB as opposed to FS)

 

You should be okay as you are not trying to sell anything

 

Bump

 

I may have a set of OEM ucas if I didn't chuck them when I moved. Had 30k on them. I'll look. Send me a PM to keep it on my radar.