SOLD ….

I just upgraded to Meso’s Switch-Pro panel and I longer need this.

This is the factory left cubby panel and the switch set up looks like this ..



This is the panel I’m selling , it is missing the tall blank switch on the right. I used that for my garage door mod. There is also a hairline crack on the backside of the cargo switch area. The crack doesn’t effect the switch being installed. It still snaps in tight.




Asking $30.00 shipped to the lower 48

 

Bump

 

Sub. I might want it. I'll check what my current setup is.

 

It won't work for me but glws!

 

Pmd

 

id take it but im in Ontario
can you take a picture of the back anyway? wondering if I could put a switch beside the cubby for my Redarc trailer break switch

 

#2 if it falls through. I can paypal, Venmo, or zelle.

 

You can add a switch to the side of the cubby, however you might need to trim the dash console side for any Interference for the new switch.

in these locations depending on where your switch is

 

oh I didn’t realize there were the clips right there. That may not work then. does the cubby just pull right out?

 

4 screws on the back side to remove.

 

How do you get at the screws

 

you pop the panel out shown above then you will see on the back side of the cubby. Like pulling out a kitchen drawer and on the back side you see the screw for the handle, just unscrew and remove. I don’t have a pick unfortunately but I’m sure OP can take one since he has this removed already.

 

ok thank. do you happen to know if on a 2016 where there is no second small switch cutout, if the back is flat?

 

Hmm, I don’t remember. It might be?

 

Sold