1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

What have you done to your Tacoma today? 1st Gen Edition

Discussion in '1st Gen. Tacomas (1995-2004)' started by SlimDigg, Feb 7, 2011.

  1. Mar 29, 2020 at 12:19 AM
    Empty_Lord

    Empty_Lord Toyotaholic

    Joined:
    Mar 13, 2016
    Member:
    #181186
    Messages:
    28,286
    Gender:
    Male
    First Name:
    Dan
    Northwest Indiana/Chicagoland
    Vehicle:
    66 Mercedes, 93 mr2, 95,98,01,02 Tacomas, 05 Tundra + others
    Too many trucks and mods to list.. check builds
    dang it i need a reg cab 5 lug now.
     
  2. Mar 29, 2020 at 12:22 AM
    2Runner

    2Runner Well-Known Member

    Joined:
    Jan 20, 2020
    Member:
    #316661
    Messages:
    1,042
    First Name:
    Scott
    So Cal
    Vehicle:
    2002 Regular Cab 2.4L MT 2WD
    More than you know!! :thumbsup:
     
  3. Mar 29, 2020 at 12:57 AM
    Empty_Lord

    Empty_Lord Toyotaholic

    Joined:
    Mar 13, 2016
    Member:
    #181186
    Messages:
    28,286
    Gender:
    Male
    First Name:
    Dan
    Northwest Indiana/Chicagoland
    Vehicle:
    66 Mercedes, 93 mr2, 95,98,01,02 Tacomas, 05 Tundra + others
    Too many trucks and mods to list.. check builds
    im enjoying the reg cab tundra life. and the taco has to get done... and i plan on buying an MR2 this year... shit. i have to make room for a 5 lug too
     
    2Runner[QUOTED] likes this.
  4. Mar 29, 2020 at 7:46 AM
    kuntry09

    kuntry09 Well-Known Member

    Joined:
    Jun 12, 2011
    Member:
    #58140
    Messages:
    590
    Gender:
    Male
    First Name:
    Cam
    Douglas, Georgia
    Vehicle:
    '99 extended cab Tacoma 4x4 converted Prerunner
    When I did my conversion, I used the bearings that were in the used spindles. Long story short, replaced them soon after installation, shopped pressed in one bearing incorrectly but fixed the issue. Soon after that, the bearing they ‘fixed’ had play. If you end up having to replace yours, be sure whoever presses yours in does it the correct way.

    Others have brought up a good point I haven’t thought about doing, checking the nut on the back side of the spindle. I may have to look at my ‘bad’ one again.
     
  5. Mar 29, 2020 at 8:43 AM
    opteron

    opteron Well-Known Member

    Joined:
    May 27, 2014
    Member:
    #130756
    Messages:
    1,348
    Gender:
    Male
    whittier, CA.
    Vehicle:
    2003 DB 4x4 SR5
    Leer camper, bug-rug, fox suspension 2.0 rear, fox 2.5 front, BAMF sliders and LCA, TRD fake 3 piece rims
  6. Mar 29, 2020 at 9:30 AM
    Kevins60

    Kevins60 axle wrap tells me my rear brakes are working

    Joined:
    Dec 23, 2018
    Member:
    #276677
    Messages:
    1,215
    Gender:
    Male
    First Name:
    Kevin
    Odessa FL
    Vehicle:
    ‘04 4cyl SR5 AT Pre-runner Garage Queen
    SCS Cruise Westin step bars Lund tonneau Jensen HU
    Treated the garage queen to a tank of 93 octane from the local Sunoco. $2.51/ gallon. Should last a while since it’s not my DD and i can’t drive anywhere anyhow with this damn covid zombie apocalypse
     
    Bridge4 likes this.
  7. Mar 29, 2020 at 9:34 AM
    nagorb

    nagorb Should be a dang perma mod

    Joined:
    Feb 28, 2011
    Member:
    #52025
    Messages:
    9,352
    Gender:
    Male
    Alabama
    Vehicle:
    2001 dbl cab 4x4
    $1.65 at Shell today. When I left CA it was just under $5. It really is crazy how much more expensive it is to live there.
     
    techfinsoup[QUOTED] likes this.
  8. Mar 29, 2020 at 10:00 AM
    JasonLee

    JasonLee Hello? I'm a truck.

    Joined:
    May 9, 2014
    Member:
    #129454
    Messages:
    12,161
    First Name:
    Jason
    Q322+3C Denver, Colorado
    Vehicle:
    15 TRD OffRoad
    TRD Supercharger and more.
    Why are you wasting money on 93 octane?
     
  9. Mar 29, 2020 at 10:02 AM
    Bridge4

    Bridge4 Well-Known Member

    Joined:
    Jan 19, 2018
    Member:
    #241694
    Messages:
    5,280
    Gender:
    Male
    MA
    Vehicle:
    2003 DCSB Imperial Jade
    I do it too. Only non-ethanol around here is 91 in vt, all my engines but the diesels get it:thumbsup: 93 in MA or when traveling.

    I know it is sort of a waste, but I feel like its a treat for the truck being a good boy.:anonymous:
     
    ontarioyota, Pyrifera and BeLance89 like this.
  10. Mar 29, 2020 at 12:12 PM
    Kevins60

    Kevins60 axle wrap tells me my rear brakes are working

    Joined:
    Dec 23, 2018
    Member:
    #276677
    Messages:
    1,215
    Gender:
    Male
    First Name:
    Kevin
    Odessa FL
    Vehicle:
    ‘04 4cyl SR5 AT Pre-runner Garage Queen
    SCS Cruise Westin step bars Lund tonneau Jensen HU
    It’s like spending money on ice cream. Do I need ice cream? No. It’s a treat. Do I feel even better about it of it’s on sale? F yeah. When I saw the price on the pump I figured why not. It was less than I was paying for 87 octane a couple weeks ago and my butt dyno says the truck runs better.
     
    ontarioyota, Bridge4 and Phessor like this.
  11. Mar 29, 2020 at 6:10 PM
    Captain Magma

    Captain Magma Well-Known Member

    Joined:
    Apr 25, 2016
    Member:
    #185258
    Messages:
    1,566
    Gender:
    Male
    First Name:
    Patrick
    Tucson, AZ
    Vehicle:
    2002 4wd DblCab
    Kings and desert pinstripes
    Knocked out a bunch of little stuff today:
    -new cup holder tabs
    -oil change
    -Cleaned the hell out of my center console while swapping tabs (it was gross underneath)
    -adjusted the auto linkage to take up front to rear play in the shifter. Shifter is rock solid now!
    -Installed a bpv bracket I had laying around
    -sealed cracked airbox, will order a new one at some point
    -installed new airbag switch blank to re-mount my Ram mount to
    -vacuumed/cleaned entire interior


    Next weekend will be:
    -new oem LBJ’s
    -new oem outer tie rods
    -remove sway bar
    -new steering rack bushings
     
    Last edited: Mar 29, 2020
  12. Mar 29, 2020 at 6:45 PM
    chrslefty

    chrslefty Well-Known Member

    Joined:
    Apr 20, 2012
    Member:
    #77258
    Messages:
    3,007
    Gender:
    Male
    First Name:
    chris
    Mesa az
    Vehicle:
    01 trd
    Stockish
    Were did you get the airbag switch blank??
     
    Bridge4 likes this.
  13. Mar 29, 2020 at 6:51 PM
    Captain Magma

    Captain Magma Well-Known Member

    Joined:
    Apr 25, 2016
    Member:
    #185258
    Messages:
    1,566
    Gender:
    Male
    First Name:
    Patrick
    Tucson, AZ
    Vehicle:
    2002 4wd DblCab
    Kings and desert pinstripes
    Right Toyota I think is where I ordered it, part # is 55524-04010. I have a double cab so I never had the switch, have my phone mount screwed into it.

    I broke the original one on accident when doing my cb install, caught my hand on the mount and ripped the whole blank out. Freak thing really, otherwise this mounting point/equipment has been SOLID.

    41364BF3-CF60-43C2-A175-250D6A5C77AA.jpg
     
  14. Mar 29, 2020 at 7:31 PM
    nagorb

    nagorb Should be a dang perma mod

    Joined:
    Feb 28, 2011
    Member:
    #52025
    Messages:
    9,352
    Gender:
    Male
    Alabama
    Vehicle:
    2001 dbl cab 4x4
    How long have you had the mount? I've had mine about a year and the ball split and feel off, still works fine though.
     
    Captain Magma[QUOTED] likes this.
  15. Mar 29, 2020 at 7:43 PM
    Captain Magma

    Captain Magma Well-Known Member

    Joined:
    Apr 25, 2016
    Member:
    #185258
    Messages:
    1,566
    Gender:
    Male
    First Name:
    Patrick
    Tucson, AZ
    Vehicle:
    2002 4wd DblCab
    Kings and desert pinstripes
    About 6 months, aside from me hulk smashing the original setup it’s been great
     
    nagorb[QUOTED] likes this.
  16. Mar 30, 2020 at 12:32 AM
    chrslefty

    chrslefty Well-Known Member

    Joined:
    Apr 20, 2012
    Member:
    #77258
    Messages:
    3,007
    Gender:
    Male
    First Name:
    chris
    Mesa az
    Vehicle:
    01 trd
    Stockish
    Thanks man !!! You rock
     
  17. Mar 30, 2020 at 3:44 AM
    Bridge4

    Bridge4 Well-Known Member

    Joined:
    Jan 19, 2018
    Member:
    #241694
    Messages:
    5,280
    Gender:
    Male
    MA
    Vehicle:
    2003 DCSB Imperial Jade
    So you just screwed your ram mount into the corners of the blank? I have been thinking about doing this, but didn't think it would hold the mount and phone without pulling out or breaking.....
     
  18. Mar 30, 2020 at 7:39 AM
    Camtron

    Camtron Active Member

    Joined:
    Jan 22, 2019
    Member:
    #280243
    Messages:
    34
    Gender:
    Male
    First Name:
    Cameron
    Vehicle:
    98 Shitbox
    OME suspension. 33s. Sliders. Bumpers. Skids.
    3B8A7725-146A-4DB4-ABDF-AF639324B942.jpg Made room for much more tire.

    C835243F-DF56-4B5C-B41E-0FCA122B7D0E.jpg
     
  19. Mar 30, 2020 at 7:59 AM
    turbodb

    turbodb AdventureTaco

    Joined:
    Feb 9, 2016
    Member:
    #177696
    Messages:
    8,486
    Gender:
    Male
    First Name:
    Dan
    PNW
    Vehicle:
    2000 Tacoma Xcab 4x4 SR5 V6 TRD
    AdventureTaco
    Mojave East (Mar 2020)

    Preface

    You'll note pretty quickly that this trip took place right near the beginning of what has become a worldwide Covid-19 pandemic. At the time of the trip, there had been approximately 600 cases and 24 deaths across the USA. 18 of those deaths were from the Life Care assisted living community in Kirkland, WA. Schools at all education levels were still open, and while some companies were starting to allow employees to work from home, it was not widespread, and definitely not mandated. There were no travel restrictions - or even really talk of such restrictions on a broad scale - in place. We were healthy, and hadn't had any high-risk contacts.

    I say this to give some perspective, since things have clearly changed since then.

    Day 1
    Leaving home for adventure was a little different this time. Looking back now, as we headed south out of the Seattle area, we were leaving behind what would turn out to be one of the early epicenters of the Covid-19 outbreak, just before more info on the severity would come to light and large-scale cancellations and closures would become part of our world's lives. This was a trip like no other - and not because it would be full of amazing hikes and petroglyphs galore!

    Read the full story, and see all the photos in...

     
    acal, TacoYankee, chrslefty and 4 others like this.
  20. Mar 30, 2020 at 9:02 AM
    cynicalrider

    cynicalrider #NFG

    Joined:
    Jul 25, 2012
    Member:
    #83399
    Messages:
    17,094
    Gender:
    Male
    Jersey
    Vehicle:
    01 SR5 TRD 4x4, '23 Bronco Wildtrak, 2017 HSQV FE350
    Drop bracket lift and booger welds
    Didn't need to cut the body mount?
     
    Taco critter and Bhakti like this.

Products Discussed in

To Top