Switch Pros 9100 install and BS thread

Check Here
https://www.shapeways.com/product/8A22XRNYG/2016-toyota-tacoma-overhead-center-switch-panel



And @MESO might also be able to help. https://mesocustoms.com/


Best,

J

 

I agree. I'd like to move my traction control switch up top. However that makes me nervous having to splice wires to extend it to reach that far. I haven't looked to see if there are extensions made for it either.

 

Well in reality it's either going to work or its not. Making a 12" extension or a 6' extension still requires the same amounts of cuts and solder joints. Go slow, use good quality heat shrink over your connections and keep your wires labeled with corresponding OEM wires. You can do it...

Plenty of good videos on YT about splicing and soldering... It's a skill worth learning

Or just put that auto high beams up there


Just dive in - Nothing like doing this to a brand new 2020 but I had a bunch of electrical mods I needed done...

 

It’s way easier working on a new truck than an older one. Everything is fresh and comes apart without breaking for the most part

 

So I figured out the best option is to do a Meso Custom...custom order. Didnt see the options of their complete custom panel. Thanks for your advice and input.

This way I dont have to splice or rewire anything and can keep my traction control switch where its at.

 

So far so good ! Now to mess around with the app

 

Nice! How long do you think it took?

 

Probably two full days including running all the wiring for accessories and building some of the cable harnesses, adding split loom and labels etc. This thread doesn’t cover cabling for ditch lights, roof racks, and rear bumper lights. If you know cable paths and don’t need to YouTube stuff like I did, I can see a much shorter install. I also like to test fit and mock stuff up first so that took time. Front bumper stuff was a breeze. I think the power trays route might have been quicker. I customized the SDHQ mount.

 

Welp...looks like a several day project for me because I don't know crap about wiring or stuff like this.

 

Where did you get that panel mount? So nice.

 

The panel mount is sold by @MESO on his website: https://mesocustoms.com/collections/toyota-tacoma-3rd-gen .

Everything he does is top quality.

 

Is the switch pros supposed to work with the ignition off? It works just fine as long as the truck is running or in acc. Doesn't make sense that the switch would be dead when truck is off

 

You can configure it to work with ignition off if you want. Or just certain switches

 

Check out this install of the new RCR-Force 12. The new power module and switch panels are huge! Now I need to find a better mounting solution.

I'll start a new thread for this new product.

Let me know if you have any questions!

 

The new panel is super big. I have one sitting on my desk and trying to stuff it in a switch panel (cleanly)

 

So many buttons

 

I think a longer and narrower panel would have been better 2x6 instead of 3x4.

 

Not sure if it’s really worth the $400 premium to have an additional 4 switches...also, that panel is yuuuge

 

Makes sense for Tacoma’s. Maybe they had other vehicle layouts to consider... I dunno. But I would imagine most cars have a 3”x8” strip somewhere near the steering wheel that would work with a 2x6

 

My buddy @Synergy001 suggested a panel over the Qi charger area. That would work if this spot is too small.

Let me know if you want a test subject!